Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-02-2009, 11:47 PM
|
#1 |
|
Registered Member
Join Date: Jan 2000
Location: Corpus Christi, Texas
Posts: 66
|
Engine potential
After rebuilding my engine I cannot get over 5k RPM, it starts missing badly. Before the overhaul I could get over 7k with no cutting out. I'm running 12 degrees advance. I've replaced my stock fual pump with a Holley blue electric pump. Any one got any Ideas on why I can't get any higher on my RPM.
Also this is only under a load, because I can sit in the driveway and rev it over 7 k and it doesn't cut out at all,,,just when I try to run it hard down the road.
__________________
66 coupe, 306 balanced bluprinted, performer intake,725 Road Demon, Crane Cam, Tri-Y Headers, factory Shelby glass packs 2 1/4 with exit in front of rear wheels, 3:50 rear, 8 inch rear, mustang plus suspension, 41/2 mideye leafs, 620 springs on front, kyb gas shocks. tony branda shelby hood, r-model valance, rear side scoops(functional),stainless steel slotted front brake system,,13.39 1/4 mile with no slicks and no posi. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| et potential? | StripedStangLX | Windsor Power | 1 | 01-14-2003 06:46 AM |
| Potential engine grenade | RPM427 | Windsor Power | 5 | 06-16-2002 09:39 AM |
| 4V Potential | 97snakedriver | Modular Madness | 1 | 06-06-2001 04:56 PM |
| 14 Sec. potential?? | 84Stang | Modular Madness | 2 | 01-20-2001 05:36 PM |
| 281 potential | StoplightWarrior | Modular Madness | 2 | 12-14-2000 03:14 PM |