Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-10-2002, 04:53 PM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Atlanta Area, USA
Posts: 42
|
Autometer Vaccum Pressure Guage...Help
In the instructions for connecting the guage it says to "Connect line to pressure port on engine by using 1/8" adapter and T-Fitting". My question is....Where is the best place to splice into? Has anyone installed one of these, and if so, please be as specific as you can with the location of the vaccum line, since they all look the same to me! Thanks in advance.
I've been pulling my hair out for about an hour now, and I'm no closer than I was before (just balder!). |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AutoMeter 99-up Guage Pod in '96??? | victorylane | Modular Madness | 1 | 03-26-2004 10:09 PM |
| Is your Oil Pressure Guage Real? | Rusty12 | Modular Madness | 6 | 10-28-2003 11:44 PM |
| fuel pressure guage question.. | avbcon12 | Windsor Power | 2 | 04-09-2002 04:52 PM |
| autometer fuel pressure guage install | mimicons | Windsor Power | 3 | 04-09-2002 12:18 PM |
| Autometer oil guage question! | jpumpkinn | Windsor Power | 7 | 01-21-2002 01:46 PM |