Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-25-2002, 07:18 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
302 Rebuild suggestions
I am planning a rebuild of a 302 for my 85 GT. Plans include:
New forged pistons (TRW or TFS) New Cam... TFS(need recommendation on which one) New TFS Twisted Wedge heads w/ Roller Rockers Balancing of motor, including flywheel. New Roller Lifters. with Performer RPM Intake and Holley 650 Carb. MSD Ignition 4.10 Gears I am shooting for about 350 HP?  Which cam should I use from TFS, and am in doing anything wrong in this set up? Total cost should be around $2,600. This car is mostly for the track and occasional street driving. Any comments appreciated. How much would i gain from a 351 block?
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rebuild or not to rebuild??? | NotchStang59311 | Windsor Power | 9 | 04-14-2004 05:28 PM |
| T-5 Rebuild | 95/GT/5.0 | Windsor Power | 9 | 12-26-2002 10:23 PM |
| TRANS rebuild kits for 5spd | drtbiker | Windsor Power | 3 | 08-18-2002 04:25 PM |
| Low cost rebuild. | salcmc | Classic Mustangs | 3 | 09-11-2001 09:16 PM |
| 99 GT, auto tranny rebuild | red99stang | Modular Madness | 5 | 05-22-2000 03:37 AM |