MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Classic Mustangs (http://forums.mustangworks.com/forumdisplay.php?f=10)
-   -   Speedometer Cable to Transmission O-ring (http://forums.mustangworks.com/showthread.php?t=43450)

Kisner 07-05-2004 12:30 PM

Speedometer Cable to Transmission O-ring
 
I noticed that my transmission is leaking slightly where the speedometer cable goes into the transmission. I purchased a new o-ring and plan on installing this weekend. However, my question is this. Does that particular part of the transmission hold a lot, or any transmission fluid when the engine is off? Just curious if I need to drain the fluid before I pull it out or not? Sure don't want to remove it and have one big mess. Thanks.

Rev 07-05-2004 02:54 PM

C-4?
 
On my C-4, the fluid level is below the spedo connection. And it doesn't have to be the O-ring leaking. Sometimes it's just the attatchment of the cable housing to the spedo connector that leaks a little. Only a new cable will cure that.

Rev

rwhite65 07-06-2004 01:46 AM

u can change it without it leaking too much. The fluid level is below the speedo hole, but there will be a little residue there anyhow.
Ryan

Kisner 07-06-2004 02:13 PM

Hey thanks. I have an aftermarket pan with a drain plug, but I didn't want to drain it if it wasn't necessary. Hopefully, my leak is from the o-ring only. If not, it's not that bad that I couldn't live with it.


All times are GMT -5. The time now is 06:21 PM.