MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Website Community > Blue Oval Lounge
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 05-07-2001, 12:08 AM   #1
1BadMoFo5.0
Guest
 
Posts: n/a
Exclamation Reply To J-Spec Engine Question

I have some knowledge on this subject becuase my best friend has a 93 MX6 (Mazda's version of the Probe) and his brother has a 92 240 SXSE. Anyway they are both comtimplating the J-Spec engine swap. They J-Spec engine have better air flow, better vavle timing, ususally a stronger crank for higher revs. The high grade octane level in Japan is 110 and this engines usually run on that grade. I know a guy personally that swapped a stock Probe engine for the J-spec one and ran 93 octane. He dynoed at 162 with everything stock beside the engine. Then a few months later he ran 100 octane for a few weeks and dynoed at 175. So go figure but everyone I know that talks about the J-Spec engine swap debates the fuel question.

------------------
89' 5.0 GT Convertible Mustang and a 69' Mustang Mach 1 Fastback. If you want to know the rest, buy the rights.
AOL name: Woodnutz351
  Reply With Quote
Old 05-07-2001, 11:23 AM   #2
inferno
The Instigator
 
inferno's Avatar
 
Join Date: Jul 2000
Location: So Cal and Houston
Posts: 764
Post

Quote:
Originally posted by 1BadMoFo5.0:
I have some knowledge on this subject becuase my best friend has a 93 MX6 (Mazda's version of the Probe) and his brother has a 92 240 SXSE. Anyway they are both comtimplating the J-Spec engine swap. They J-Spec engine have better air flow, better vavle timing, ususally a stronger crank for higher revs. The high grade octane level in Japan is 110 and this engines usually run on that grade. I know a guy personally that swapped a stock Probe engine for the J-spec one and ran 93 octane. He dynoed at 162 with everything stock beside the engine. Then a few months later he ran 100 octane for a few weeks and dynoed at 175. So go figure but everyone I know that talks about the J-Spec engine swap debates the fuel question.

I assume he played with the timing too or was using the Japanese ECU. The US ecu won't adjust the timing for anything higher than 94 octane fuel so you really won't see any more hp. So basically he had the engine and a "chip". That goes along with what I said in the other post.

------------------
90 Honda CRX aka Project Mongoose
Estimated Completion: 7/1/01
453 horses with a stock head...built head and LSD on the way

84 Toyota Supra
High flow cat, two chamber flowmaster, custom 2.5" piping, msd 8.5mm wires. Will have boost before 2002.
Have HKS turbo manifold for it.....T04e next week

inferno is offline   Reply With Quote
Old 05-09-2001, 09:30 AM   #3
1BadMoFo5.0
Guest
 
Posts: n/a
Post

Yep it was a full blown conversion after the chip was installed.
  Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Engine Code Question Bad89stang Windsor Power 1 02-29-2004 11:36 AM
GT40 crate engine question dlb1982 Windsor Power 2 09-24-2002 09:42 AM
Question about rebuilding engine setherek Classic Mustangs 3 09-22-2002 10:41 PM
Engine Shifting into radiator and also clucth broke Stuffie0912 Classic Mustangs 2 12-03-2001 03:26 AM
Very bad experience with Engine Dynamics of San Jose CA JAGraff Small Ponies 0 05-12-1999 02:27 AM


All times are GMT -5. The time now is 11:23 PM.


SEARCH