PLease check this diagram and see if this wiring for the battery switch will pass tech:
I also need to know if 4AWG wire will be enough for the alternator to the distribution block.
__________________
Engine:
1990 5.8 / Edelbrock Performer set-up
MSD ignition
Suspension:
Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors /
Drivetrain:
Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel /
5.8 in the hole