© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-07-2002, 03:39 PM | #1 |
Registered Member
Join Date: Mar 2002
Posts: 7
|
any drag launching advise?
I have been to the track resently and I have seen that my launch sucks. I have tried reving it up then dropping the clutch. I have tried easing out the clutch until it barely touches the flywell and reving it up and launching. I either end up in massive wheelspin or a small bog followed by a launch at idle. If you have any advise that can help me out in turning up better slips please feel free to respond, thank you.
|
09-07-2002, 03:40 PM | #2 |
Registered Member
Join Date: Mar 2002
Posts: 7
|
By the way i have a 01' Gt with a K & n aircharger with some flowmasters and an off-road Mac X-pipe.
|
09-08-2002, 03:30 AM | #3 |
Registered Member
Join Date: Mar 2002
Location: Los Angeles
Posts: 34
|
you should probably try holding the revs at around 1800 to 2500 (depends on your engine capability) and then just take your forr off the clutch completely... and then you have to control the tire spin with your gas pedal. minimize the spin but dont let yourself bog down. If you do it right, you should have a little spin right off the light and then hook shortly after. Youll know the launch was good when you feel it in the butt
__________________
2001 GT with Steeda u/d Pulleys, Steeda timing adjuster, 3.73 gears, and Tri-Ax short shifter. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
I STILL can't find the right drag radials. | Fox Body | Windsor Power | 10 | 03-08-2005 06:00 PM |
Drag Tire/Wheel Advice Please | apenn | Modular Madness | 5 | 06-19-2002 11:40 PM |
New 1/4 mile ET from the drag strip!!!!!!!!!! | Fox Body | Blue Oval Lounge | 18 | 03-11-2002 05:22 AM |
Questions Regarding Drag Wheels and Tires | elmir50 | Blue Oval Lounge | 1 | 11-26-2001 11:45 AM |
I STILL can't find the right drag radials! (Long, but please help.) | Fox Body | Racer's Club House | 2 | 04-13-2001 01:17 PM |