© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-18-2000, 10:50 PM | #1 |
Registered Member
Join Date: Oct 1999
Location: Pierre Part, La. U.S.A.
Posts: 1,850
|
milled edlebrock heads
I have a set of elelbroc performer heads, They had 60cc chambers and 1.94/1.60 valves. They have been milled .020, the mill actually cut a fraction of the outside of the valve seat. Will this hurt anything? and what size are the chambers now? Should I do any clean up work on them (ports) or leave them alone. I hope this will make a drastic differance on my combo.
------------------ Jason B Johnson 88LX 206,000 miles, cowl hood, drag lites,92 stock short block with 96,000, E7 heads 1.94/ 1.60s,4.30s,B-303,long tubes,tremec,cobra intake,19lb-40psi,race pully,short belt,aulmdrive shaft,homemade ram air,70/100 hp NOS dry, 70/30 lake woods, 4cyl springs, air bags, boxed lowers, stock uppers,1.6rr,MSD 6-a & coil, timing control, batt in rear,drive it like I hate it. 12.98@108.64radials 2.0 60ft 12.59 @ 108.55 slicks 1.79 60ft 12.11 @ 111.898 slicks 1.64 60ft, NOS 100hp jet, 550-600psi bottle |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ported e7's? | bailey_57 | Windsor Power | 28 | 07-15-2004 07:54 PM |
71 2v Cleveland heads on a mild 302 | crazypete | Windsor Power | 3 | 06-18-2004 07:05 PM |
??? about 351W heads on a 302 | vande97 | Windsor Power | 2 | 05-15-2002 10:42 AM |
What kind of Windsor heads? | vetteeatr | Windsor Power | 11 | 10-28-2001 03:43 AM |
Which heads are beter? | patman | Classic Mustangs | 3 | 12-02-1999 03:42 AM |