MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Racing > Racer's Club House
Register FAQ Members List Calendar Mark Forums Read

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 02-01-2001, 04:52 AM   #1
WADS56
gear banger
 
WADS56's Avatar
 
Join Date: Aug 2000
Location: CHICAGO
Posts: 1,144
Post need help with gear selection

I am looking to get into low to mid 10's with a high ratio so I can get a good launch. I now have 4.10's and am crossing the traps at about 116mph at 62-6400 rpm in fourth gear with my tremec. Now I have some good heads on the way with more boost from my vortech so the 4.10's are way to high.
I looked at the gear finder on some tech sites and 3.55's and 3.73's put me where I wanted to be, but the 3.73's will give me the better launch and the 3.55's will allow me to use some more of the engins tork down the strip. My motor is built up for mid to top end
(cam#'s 6.66 258@.50 heads flow 300 on the intake and 235 on the exhaust) what do you think should go in the rear?

------------------
Blown 347 W/Canfield heads, solid roller cam, track times this spring mid 10's or bust

93lx 5.0 daily driver
WADS56 is offline   Reply With Quote
Old 02-01-2001, 07:39 AM   #2
Jeff Chambers
Moderator
 
Jeff Chambers's Avatar
 
Join Date: Aug 2000
Location: Milan, OH
Posts: 2,699
Post

I'm sure the blower guys could give you better advice but I'll take a stab at it. For 10's you're looking at MPH in the range of 126 to 136. If you've got the capability to spin the motor high, then the 3.73's would be the ticket. But if you're still running long-runner intake and shifting below 6500 then I'd go with the 3.55's. They may not hit as hard as the 3.73's, but you should be able to overcome that fact with the monster torque and hp you'll be making across the entire rpm. You ought to jump over to funford.com and as the same question out of the blower guys in the Renegade class. They've probably been there and had to face the same decisions.


------------------
Jeff Chambers
Trophy Stock #3
11.97 Seconds / 114.5 MPH
Chambers Racing Team
Jeff Chambers is offline   Reply With Quote
Old 02-02-2001, 06:56 AM   #3
WADS56
gear banger
 
WADS56's Avatar
 
Join Date: Aug 2000
Location: CHICAGO
Posts: 1,144
Post

I think I will give the 3.55's a try and put my car on a huge diet. My car is a 79 hatch and I heard that they only weigh like 2900lbs from the factory. If I strip it of everything that I don't need including the heater this thing should fly.
WADS56 is offline   Reply With Quote
Old 02-03-2001, 06:44 PM   #4
302man
Registered Member
 
302man's Avatar
 
Join Date: Jul 1999
Location: INDIANAPOLIS
Posts: 404
Post

I had the 3:55 in my car and with a 4000stall, my car slowed down over foot brakeing it at 2200. I make more torque down low so I switched to 3:73's. Most of the renegade guys run 3:73's and a 28" tire.

------------------
302,vortech s trim @18-20lbs showing,edelbrock performer heads-o ringed,gt 40 upper&lower, mac 1 5/8"long tubes, sub frame connectors,50/50 rear, 70/30 front, manual rack,3:55 gears, c4 , best time 10.13@135mph
302man is offline   Reply With Quote
Reply


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
raced a Supra Twin Turbo Stang35th Stang Stories 63 08-23-2003 12:36 AM
Gear Ratio Selection Green96GT Modular Madness 4 07-19-2001 11:40 AM
Need Some Help with Gear Selection StangDan Windsor Power 6 05-19-2001 08:28 AM
98 gt, gear selection? White5.0 Modular Madness 5 01-29-2001 01:18 PM
Gear selection Grulla Corner Carvers Delight 1 03-13-2000 09:04 AM


All times are GMT -5. The time now is 06:04 AM.


SEARCH