Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-07-2006, 11:43 PM
|
#6 |
|
show me my opponent
Join Date: Sep 2006
Location: El Paso Texas
Posts: 12
|
Re: Anyone running a C-4 tranny I need HELP!!!!!!!!
hey I have a question since you seemed to have figured out your problem, were converting this 93 coupe 4 cyl to a 351w swap, I'm going to run a c-4 tranny and i have the true dual cross member so the bushing housings are not welded yet, from what I read I guess it will bolt up fine then I weld it, but beyond that, did your driveshaft fit right? and was the slip yoke the right splines?
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Yet another tranny fluid ?? | Simi Stang | Windsor Power | 4 | 09-30-2003 12:44 PM |
| Tranny and rear end q | Nixon1 | Windsor Power | 0 | 02-21-2003 02:06 PM |
| Tranny update...Lentech VB | silver_pilate | Blue Oval Lounge | 10 | 05-02-2002 12:34 PM |
| The Motor Runnning and then...........Tranny | Stang Runner | Windsor Power | 0 | 12-12-2001 01:48 PM |
| This is bad! Did my Uncle cause my Racing tranny to overheat?(It's a long 1... sorry) | Stang_ROTY | Windsor Power | 1 | 08-30-2001 10:55 PM |