Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-20-2002, 08:43 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
Harness
Ok what harness should I get. I was looking at the Simpson 5point camlock. Is this a good harness, and what length should I get?
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine wiring harness | Dog5ohfun | Windsor Power | 2 | 04-25-2004 11:35 PM |
| New Main Harness M-12071-c302 | Mountain Main | Windsor Power | 10 | 06-18-2003 04:57 AM |
| 88 harness to 90 efi 5.0 harness | UCMEFLY2 | Windsor Power | 0 | 09-10-2002 07:06 PM |
| Which wiring harness and computer do I have to have? | EazyE-CPT | Windsor Power | 0 | 07-21-2002 11:33 PM |
| whats up with this wiring harness? | LX XLR8R | Windsor Power | 3 | 08-17-2001 10:53 AM |