View Single Post
Old 02-07-2001, 10:30 AM   #1
96SNAKE
Registered Member
 
96SNAKE's Avatar
 
Join Date: Jan 1999
Location: allentown,pa,u.s.
Posts: 780
Post Terrible wheel hop

I need help with this and was wondering if anybody came across this problem before.

My 96 hops violently on hard launches, forcing the driveshaft into the driveshaft tunnel. When it does this, the brackets holding the parking brake cables, cut into the driveshaft, almost trying to saw right through it. It is doing this in other parts of the tunnel as well. To stop this, I have replaced the shocks and struts, quad shocks and rear upper control arms.

What should be next, the lower control arms or the Eibach springs? I have heard the Eibachs can go bad over time but the car has no noticeable sag on any side??

Thanks!

------------------
formerly 96cobra89lx306

(96Cobra/softtop-3.73,almdrvsht,fancontrl,steeda sbfrmes+shifter,eibachspgs,KYB's,FR-upper arms,Saleen copy-polished 18's,pulleys,Bassani X pipe(gutted),C&L 80mm
Cobra DYNO 301rwhp horsepower before gutting the X pipe
93 Ford Probe Gt(slower but turns)

[This message has been edited by 96SNAKE (edited 02-07-2001).]
96SNAKE is offline   Reply With Quote