14.691@94.70 FINALLY!!!

BowTie Eater 5 Liter · 10-06-2001, 04:00 PM

R/T ... .866
60 .... 2.240
330 ... 6.190
1/8 ... 9.477
MPH ... 74.61
1000 .. 12.309
1/4 ... 14.691
MPH ... 97.70

Thats With A 2000rpm Slip, And No Powershifting.

Now I Need To Finish Off My Exhaust And Go Low 14s....

------------------
1988 Mustang GT, T-5
3.08's, No Smog Pump (Shorty Belt), Dynomax 2.5" Super Turbo Cat-Back, K&N Air Filter (Stock Air Box), Removed Air Silencer
14.691 @ 94.7 With A 2.24 60ft.

1988 Mustang GT

Dark_5.0 · 10-06-2001, 04:28 PM

Me and you would be a good race. I got my best time last weekend.

reaction--.522
60 ft-----2.0754
330 ft----6.1396
1/8th mi--9.4873 @74.01
1000 ft---12.3592
1/4 mi----14.7959 @93

Nice time

With 3.73's and some cheater slicks you will be a low 14 sec. car

If I were you I would get some nitto's as my next mod you can fit a 245 wide and that should get you 2 flat 60's and about a 14.3

Good luck!

------------------
88 mustang gt convertible bored to 306 BBk equal length headers, mac cold air fender kit, 3.73 FMS gears, Steeds Tri-ax shifter, Steeda underdrive pullies, Custom off road X-pipe, 2 chamber flow masters, cowl hood, nitto drag radials, ford racing clutch, 160* thermostat 16 degrees of timing electric fan off 94' t-bird jacobs electronics cap and wires. Edelbrock 1 1/2 inch drop springs. (Best E.T. 14.79@93mph @3000ft)

Skyman · 10-06-2001, 04:51 PM

Nice time. Did you run 97 or 94 mph?

Skyler

------------------
-1989 Saleen Mustang #406-
TFS TW Heads, E-303, Edelbrock intake, 70mm TB, 73mm MAF, 24lb injectors, 1 5/8 shorties, Off Road H, 3 Chamber flows, Jaz Race seats, Back seat removed, sub-frames, Roll Cage, and a 80 shot of N20.
12.54@107.4 Motor
332RWHP, 350rwtq

Unit 5302 · 10-06-2001, 06:01 PM

Well you got your 14's.

Now it's off to the 13's zone. LOL!!

Rev · 10-06-2001, 06:11 PM

What headers are planned? Correct ones should help.

Rev

------------------
'66 Coupe, 306, 300 HP, C-4, 13.97 e.t., 100.3 mph
1/4 mi.

[This message has been edited by Rev (edited 10-06-2001).]

BowTie Eater 5 Liter · 10-07-2001, 08:07 PM

sorry, thats a 94.70mph

i have bbk 1-5/8" equal legnth shortys, and can get a off road h pipe.

that should help to a 14.2 or so (i hope)

90dpscoupe · 10-07-2001, 10:40 PM

Electric fan, i went from 94mph, to 98.

------------------
90 lx coupe: 5spd, energy susp trans mounts, fms hd clutch, Mac coldair fenderwell, Mac h-pipe, supercoil, ADS chip, 160 stat, aluminum D/S, Black magic fan, 3.27grs.
Best time: 13.9116(on 225/60/15 firehawks)
Best mph: 98.17
Best 60': 1.9607

someday mods:4.10's, slicks.

stanger8172 · 10-10-2001, 11:43 PM

Congrats on your new time!

I just finished installing BBK 1 5/8" equal length shorty's tonight. If you need advice just e-mail me or post it.

------------------
'91 LX convertible , T-5,Centerforce Dual Friction, FMS adjustable cable w/quadrant, ported/polished/milled E7 heads, 1.6rr, 1.94/1.60 stainless valves, BBK 1 5/8" equal length shorties, 2 1/2" off road H-pipe, Summit 2 1/2" catback, March Performance Pulleys and A/C Eliminator

jetuomi · 10-12-2001, 09:22 AM

hey, nice times, I'm still a bit behind ya!!

------------------
94 GT (triple black)
FMS 95 17" Cobra R's / AL Driveshaft / 3.27's
K&N, 12* timing, 180* thermostat, 190 lph
MAC Shifter/Gauges/Pedals, Euro Clear Projectors & Corners
My CAR!

jonnyk · 10-13-2001, 07:22 PM

Nice 60's Bowtie, especially with stock gears. I wish I was at sea level with you

------------------
'91 LX Hatch, 17x8.5 ROH ZR6's, lowered, 3.73's, offroad H pipe, SN Cobra cat-back, ASP pullies, 14° timing, C&L 76mm MAF, 170A 3G, B&M Ripper on a T5
Best ET run: 14.593 @ 94.62, 2.292 60'
Best MPH run: 14.728 @ 95.72 mph, 2.423 60'
Best 60': 2.230
1991 LX Hatch 5.0L

10-06-2001, 04:00 PM	#1
BowTie Eater 5 Liter Registered Member Join Date: Nov 2000 Location: Maple Ridge B.C. Canada, The Best Place In The World Posts: 871	14.691@94.70 FINALLY!!! R/T ... .866 60 .... 2.240 330 ... 6.190 1/8 ... 9.477 MPH ... 74.61 1000 .. 12.309 1/4 ... 14.691 MPH ... 97.70 Thats With A 2000rpm Slip, And No Powershifting. Now I Need To Finish Off My Exhaust And Go Low 14s.... ------------------ 1988 Mustang GT, T-5 3.08's, No Smog Pump (Shorty Belt), Dynomax 2.5" Super Turbo Cat-Back, K&N Air Filter (Stock Air Box), Removed Air Silencer 14.691 @ 94.7 With A 2.24 60ft. 1988 Mustang GT

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Finally got a 5.0!	'94Vert5.0	Windsor Power	3	04-12-2003 08:29 AM
I finally shut him up	bigred90gt	Stang Stories	9	01-27-2003 04:53 PM
Nitrous times, finally.	chris91LX	Windsor Power	4	11-11-2002 07:58 PM
AIt's finally here...(kina Long)	Stang951	Windsor Power	0	06-19-2001 12:00 PM
THE BIG SHOT FINALLY WORKS!!!	NOSstang89	Windsor Power	2	05-16-2001 12:04 PM

10-06-2001, 04:28 PM	#2
Dark_5.0 Registered Member Join Date: Apr 2001 Location: Staging lane Posts: 4,337	Me and you would be a good race. I got my best time last weekend. reaction--.522 60 ft-----2.0754 330 ft----6.1396 1/8th mi--9.4873 @74.01 1000 ft---12.3592 1/4 mi----14.7959 @93 Nice time With 3.73's and some cheater slicks you will be a low 14 sec. car If I were you I would get some nitto's as my next mod you can fit a 245 wide and that should get you 2 flat 60's and about a 14.3 Good luck! ------------------ 88 mustang gt convertible bored to 306 BBk equal length headers, mac cold air fender kit, 3.73 FMS gears, Steeds Tri-ax shifter, Steeda underdrive pullies, Custom off road X-pipe, 2 chamber flow masters, cowl hood, nitto drag radials, ford racing clutch, 160* thermostat 16 degrees of timing electric fan off 94' t-bird jacobs electronics cap and wires. Edelbrock 1 1/2 inch drop springs. (Best E.T. 14.79@93mph @3000ft)

10-06-2001, 04:51 PM	#3
Skyman I need 110mph Trap Speed! Join Date: Feb 1999 Location: So, CA Posts: 4,315	Nice time. Did you run 97 or 94 mph? Skyler ------------------ -1989 Saleen Mustang #406- TFS TW Heads, E-303, Edelbrock intake, 70mm TB, 73mm MAF, 24lb injectors, 1 5/8 shorties, Off Road H, 3 Chamber flows, Jaz Race seats, Back seat removed, sub-frames, Roll Cage, and a 80 shot of N20. 12.54@107.4 Motor *332RWHP, 350rwtq*

10-06-2001, 06:01 PM	#4
Unit 5302 Registered Member Join Date: May 1999 Posts: 5,246	Well you got your 14's. Now it's off to the 13's zone. LOL!!

10-06-2001, 06:11 PM	#5
Rev Registered Member Join Date: Nov 1998 Location: Houston, Tx. Posts: 3,887	What headers are planned? Correct ones should help. Rev ------------------ '66 Coupe, 306, 300 HP, C-4, 13.97 e.t., 100.3 mph 1/4 mi. [This message has been edited by Rev (edited 10-06-2001).]

10-07-2001, 08:07 PM	#6
BowTie Eater 5 Liter Registered Member Join Date: Nov 2000 Location: Maple Ridge B.C. Canada, The Best Place In The World Posts: 871	sorry, thats a 94.70mph i have bbk 1-5/8" equal legnth shortys, and can get a off road h pipe. that should help to a 14.2 or so (i hope)

10-07-2001, 10:40 PM	#7
90dpscoupe Registered Member Join Date: Jun 2000 Location: sanantonio, Tx, usa Posts: 1,407	Electric fan, i went from 94mph, to 98. ------------------ 90 lx coupe: 5spd, energy susp trans mounts, fms hd clutch, Mac coldair fenderwell, Mac h-pipe, supercoil, ADS chip, 160 stat, aluminum D/S, Black magic fan, 3.27grs. Best time: 13.9116(on 225/60/15 firehawks) Best mph: 98.17 Best 60': 1.9607 someday mods:4.10's, slicks.

10-10-2001, 11:43 PM	#8
stanger8172 Registered Member Join Date: Nov 2000 Location: Milwaukee,Wisconsin Posts: 380	Congrats on your new time! I just finished installing BBK 1 5/8" equal length shorty's tonight. If you need advice just e-mail me or post it. ------------------ '91 LX convertible , T-5,Centerforce Dual Friction, FMS adjustable cable w/quadrant, ported/polished/milled E7 heads, 1.6rr, 1.94/1.60 stainless valves, BBK 1 5/8" equal length shorties, 2 1/2" off road H-pipe, Summit 2 1/2" catback, March Performance Pulleys and A/C Eliminator

10-12-2001, 09:22 AM	#9
jetuomi Registered Member Join Date: Dec 2000 Location: Waterloo, ON, Canada Posts: 214	hey, nice times, I'm still a bit behind ya!! ------------------ 94 GT (triple black) FMS 95 17" Cobra R's / AL Driveshaft / 3.27's K&N, 12* timing, 180* thermostat, 190 lph MAC Shifter/Gauges/Pedals, Euro Clear Projectors & Corners My CAR!

10-13-2001, 07:22 PM	#10
jonnyk Being stroked is great Join Date: Oct 1998 Location: Alberta, Canada Posts: 772	Nice 60's Bowtie, especially with stock gears. I wish I was at sea level with you ------------------ '91 LX Hatch, 17x8.5 ROH ZR6's, lowered, 3.73's, offroad H pipe, SN Cobra cat-back, ASP pullies, 14° timing, C&L 76mm MAF, 170A 3G, B&M Ripper on a T5 Best ET run: 14.593 @ 94.62, 2.292 60' Best MPH run: 14.728 @ 95.72 mph, 2.423 60' Best 60': 2.230 1991 LX Hatch 5.0L