Printer Problems....
 

O.K. I just had to post this, I thought it was pretty funny. You might have seen it in an email already, but for those that haven't:


"Last week I was with one of my new full time employees named Dave in the lobby when a receptionist complained that her printer wasn't working. Dave horsed around with it and discovered a pen stuck inside the printer. He started to jam his fingers down in to the printer to get the pen, but I told him we didn't have time for that now, and to just put a note on the printer telling folks not to use it and then report it to the Help Desk. So the big stink grabbed a piece of paper and started scrawling on it. I left before he finished the note.


About 20 minutes later, one of my techs comes in and says he was just in the lobby, saw a piece of paper on a printer and went to investigate.


This is what he found..."

http://members.mustangworks.com/95mu...es/PRINTER.jpg

http://www.mustangworks.com/msgboard/biggrin.gif http://www.mustangworks.com/msgboard/biggrin.gif


------------------
1995 Mustang GT

[This message has been edited by 95mustanggt (edited 10-01-2001).]

I don't even know what to say here... http://www.mustangworks.com/msgboard/wink.gif

------------------
'91 LX Hatch, 17 ROH ZR6's, lowered, 3.73's, offroad H pipe, SN Cobra cat-back, ASP pullies, 14° timing, C&L 76mm MAF, 170A 3G, B&M Ripper on a T5
Best ET: 14.593 @ 94.62 2.292 60'
1991 LX Hatch 5.0L

ROTFLMAO!!!

That's hilarious!!

Oh my.

My wife didn't get it at first, I had to break up the "penis" to "pen is" for her. Then she laughed. http://www.mustangworks.com/msgboard/biggrin.gif

------------------
1995 Mustang GT