

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: May 1999
Location: norfolk,va
Posts: 265
|
![]() I was almost home and I was stopped at a red light. I had to keep reving my engine because I think I need my idle adjusted now. Well a Fox 5.0 came up behind me with two young kids in it. I didn't think nothing of it. I just kept reving my engine. The light turns green and I start off and look in my rear view, and I can't even see their hood! So I punch it, spin in 2nd , let off and give it 3/4 and leave them. I slow back down . They pull up next to me, jump a little and nod, so I mashed it in 3rd and put three cars on them like nothing!!! Then they had to do a ricer fly-by. Boy I need my DR's bad!
Here are my before and after numbers, 338 RWHP 361 RWTQ Now 378 RWHP 401 RWTQ Anyone have an idea what I should run in the 1/4 now? Best till now has been a 13.3@111 Also, I get my NT-555R's on Wednesday. ------------------ 95 Cobra, 9LB Powerdyne, Forged Pistons, Twisted Wedge heads, 70mm TB, Bullet 75mm Mass-air, TFS 1.7 rockers, 38lb injectors, Roller Timing Chain, Stewart Water Pump, High Flow Oil Pump, B&M Ripper, SVO HD clutch, 255lph, Full MSD system w/BTM, MAC Headers,MAC H-pipe w/cats, 3:55's,By-pass valve, Incon Check Valves,Sub-frames, Driveshaft loop, Fuel pressure regulator, flowmasters, A-pillar gauge, intake spacer. |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dyno Tune?? | Gho$t | Windsor Power | 1 | 01-10-2003 08:16 AM |
Dyno Tune in the Ohio area? | squid | Windsor Power | 2 | 01-05-2003 11:03 AM |
What is done on a dyno Tune? | Chipdog | Windsor Power | 5 | 04-09-2002 09:12 PM |
DYNO TUNE AND CHIP IN LOS ANGELES AREA | DAVE94LIGHTNING | Windsor Power | 4 | 10-30-2001 11:49 PM |
Dyno tune and chip | 95snake | Windsor Power | 9 | 02-04-2001 11:44 AM |