Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-03-2002, 04:16 PM
|
#1 |
|
Registered Member
Join Date: Jun 2001
Location: katy,tx us
Posts: 6
|
Blown Outlaw Ring Question
What material/type of rings should be used in a supercharged 25 psi SB 347 stroker motor (e.g. Street Outlaw Class)?
The top edge of the top ring is located .300" from the top of my pistons. The ring package I was sold is described below. The machinist who bored/honed my block commented that I should consider running something else so I wanted to double check before going any further. I obviously can't change the thickness of the rings now but am most interested in the choice of ring material for this high HP, high heat application. Top: 1.5mm Ductile Iron-Plasma Moly-Barrel Backcut 2nd: 1.5mm Cast Iron-Phosphate-Taper Backcut Twist Oil: 3mm std tension oil ring package |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Piston Ring Install Question | rancheroo | Windsor Power | 3 | 02-20-2004 10:07 PM |
| Blown inake question | surfbeast | Modular Madness | 2 | 10-21-2003 08:12 PM |
| Speed Secret # 7 | jim_howard_pdx | Windsor Power | 8 | 11-23-2002 02:55 AM |
| Help Quick Please! Ring gear install question??? | 90'5.0 Conv | Windsor Power | 5 | 05-03-2002 07:53 PM |
| Mr. 5.0....ANYONE...HELP!!! RING PINION QUESTION!!! | 90LxDroptop | Windsor Power | 3 | 09-08-2001 02:01 PM |