© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-30-2001, 01:33 AM | #1 |
Registered Member
Join Date: Apr 2001
Location: Staging lane
Posts: 4,337
|
New mods and new times
I installed a steeda tri-ax shifter a set of steeda underdrive pullies and a custom off road X-pipe and ran a.
Reaction-.516 60 ft----2.0754 330 ft---6.1397 1/8 mi---9.4873@74mph 1000 ft--12.3592 1/4 mi---14.79@93mph I was really happy with my 60ft considering my car is a vert with stock suspension (other than drop springs) and still has the sway bar in. 14.79@93mph @3000ft (I knocked off 6 tenths and picked up 3mph with the new mods) ------------------ 88 mustang gt convertible bored to 306 BBk equal length headers mac cold air fender kit 3.73 FMS gears cowl hood nitto drag radials ford racing clutch flow masters h-pipe 160* thermostat 16 degrees of timing electric fan off 94' t-bird jacobs electronics cap and wires. Edelbrock 1 1/2 inch drop springs. [This message has been edited by 5.0 HO (edited 09-30-2001).] |
10-02-2001, 04:34 PM | #2 |
I need 110mph Trap Speed!
Join Date: Feb 1999
Location: So, CA
Posts: 4,315
|
Nice runs, I Imagine if those were corrected they mightr be about 14.4! Not bad at all for a vert!
Skyler ------------------ -1989 Saleen Mustang #406- TFS TW Heads, E-303, Edelbrock intake, 70mm TB, 73mm MAF, 24lb injectors, 1 5/8 shorties, Off Road H, 3 Chamber flows, Jaz Race seats, Back seat removed, sub-frames, Roll Cage, and a 80 shot of N20. 12.54@107.4 Motor 332RWHP, 350rwtq |
10-02-2001, 06:32 PM | #3 | |
Registered Member
Join Date: Apr 2001
Location: Staging lane
Posts: 4,337
|
Quote:
The only bad news is now I have every bolt on that you can buy and now I have to spend some real money. I am gunning for low 14's by the first week in November wich is the last test and tune of the year. Thanks for the reply ------------------ 88 mustang gt convertible bored to 306 BBk equal length headers, mac cold air fender kit, 3.73 FMS gears, Steeds Tri-ax shifter, Steeda underdrive pullies, Custom off road X-pipe, 2 chamber flow masters, cowl hood, nitto drag radials, ford racing clutch, 160* thermostat 16 degrees of timing electric fan off 94' t-bird jacobs electronics cap and wires. Edelbrock 1 1/2 inch drop springs. (Best E.T. 14.79@93mph @3000ft) |
|
10-02-2001, 09:58 PM | #4 |
I need 110mph Trap Speed!
Join Date: Feb 1999
Location: So, CA
Posts: 4,315
|
You could still do MAF, ram air, pulleys, which will make a big difference, get a better 60', and or a fuel pressure regulator.
You should correct that time and see what it would be at sea level. Skyler ------------------ -1989 Saleen Mustang #406- TFS TW Heads, E-303, Edelbrock intake, 70mm TB, 73mm MAF, 24lb injectors, 1 5/8 shorties, Off Road H, 3 Chamber flows, Jaz Race seats, Back seat removed, sub-frames, Roll Cage, and a 80 shot of N20. 12.54@107.4 Motor 332RWHP, 350rwtq |
|
|