Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-06-2002, 12:10 PM
|
#10 |
|
Mustang Addict
Join Date: Jan 2001
Location: McKinney, TX
Posts: 1,294
|
MidNiteBlu 5.0: I have been very happy with the quality and performance increase with all the parts that I have bought from MM, and so far have not had any bad customer service experiences.
Tinseltown349: I would highly recommend getting a tubular k-member and control arms to lighten up the front. I can't believe the turn-in my car has now. As long as I do a solid weight transfer going into the corners, it just turns. Since I haven't been able to afford the panhard bar and torque arm yet to finish the rear suspension, I can actually turn in fast enough to break the back loose without using the throttle.
__________________
Strike down the unroadworthy! 2000 GT Atl. Blue: '03 Cobra motor - 465rwhp/473rwtq, T-56 6-speed, full MM TA/PH & tubular K-member suspension, Saleen body, 17" Torq-Thrust II's, M/T ET Street radials, and lots more '94 Rio Red Cobra: All the bolt-ons, 3.73s |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Strut Tower Brace | saleen243 | Windsor Power | 1 | 02-18-2003 04:52 PM |
| Help! Strut Tower Brace - Will it fit w/this intake? | daveGT | Windsor Power | 5 | 08-05-2002 04:24 PM |
| caster/camber plates used with a strut tower brace | jtl | Windsor Power | 1 | 02-10-2002 10:31 PM |
| strut tower brace | BLK99GT | Modular Madness | 4 | 05-12-2000 06:14 PM |
| Strut tower brace install? | Ripper | Modular Madness | 1 | 03-28-2000 10:47 AM |