Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-25-2001, 01:04 PM
|
#5 |
|
Registered Member
Join Date: Aug 2000
Location: santa ana ca
Posts: 1,349
|
I just spent a grand on an exh system and the longtubes fit stock heads. Unless there is a brand that will fit these headers and let me use my pedestal mount rockers instead of stud mount like most aftermarket heads I am keeping the stockers, maybe I will get them ported later. I intend to get a GT40 intake and a dyno tune with a custom chip burnt and then quit. Maybe I will finaly get a decent set of rims then. Or I will save for a new stroker shortblock.
------------------ 95GT B303 cam, 1.7 rockers, 65mm TB, 73mm MAF, milled heads, 355's K&N, off road pipes, pulleys, msd coil, 9mm wires, Tremec 3550, Pro5.0 shifter,10.5 Motorsport clutch, weld in subframe connectors |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| To Kill an American... | cyberstang5.0 | Blue Oval Lounge | 16 | 04-05-2003 07:51 PM |
| an early kill | joea1 | Stang Stories | 3 | 07-02-2002 03:17 PM |
| 1st kill since new motor.(Not much to brag about but he was just begging for it) | Five0 | Stang Stories | 3 | 09-09-2001 05:41 PM |
| Installing a Kill Switch | 66 Racer | Classic Mustangs | 3 | 09-01-2001 07:35 PM |
| 347 stroker kill !! | FivepointOH | Stang Stories | 4 | 04-11-2001 12:19 PM |