![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Jun 2001
Location: Arlington Hts. IL
Posts: 315
|
![]() Hey everyone, I was wondering if anyone has an estimate of the times I'd run. mainly for the 1/4. all I have for mods right now are on my signature...but over the winter I'm buying a TransGo shift kit...some tires...hopefully the comp t/a's..i hope they will fit or I'm open to suggestions for the tires...I want some Drag radials tho...not slicks. I wanna have them on at all times not just for the weekend. and then a set of headers...right now I think I run a 15.4 or so...it's a convertible...whaddya guys think? and any suggestions for mods? cause i'll have money since the stang will be garaged...maybe a torque converter...thanx.
------------------ 90 LX 5.0 AOD 3.73 Gears, Removed Air Silencer, more mods to come... |
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Apr 2001
Location: Staging lane
Posts: 4,337
|
![]() You will run a 15.4 at best and a 15.7 at worst.
Dont waste money on headers at this point. Get a torque converter an off road X-pipe and underdrive pullies as your next mods they will give you alot of bang for the buck. You will also need subframe connectors (for sure) on your vert. Out of all of the mods that I have done the off road X-pipe and the underdrive pulis gave me the most gain. As far as the tires go you need some 245 wide nitto drag radials for the track and street they give good performance at the track and are stil a good street tire. ------------------ 88 mustang gt convertible bored to 306 BBk equal length headers, mac cold air fender kit, 3.73 FMS gears, Steeds Tri-ax shifter, Steeda underdrive pullies, Custom off road X-pipe, 2 chamber flow masters, cowl hood, nitto drag radials, ford racing clutch, 160* thermostat 16 degrees of timing electric fan off 94' t-bird jacobs electronics cap and wires. Edelbrock 1 1/2 inch drop springs. (Best E.T. 14.79@93mph @3000ft) |
![]() |
![]() |
![]() |
#3 |
Registered Member
Join Date: Oct 2001
Location: Kensington, CT
Posts: 47
|
![]() My guess would be a 15.0-15.5:
My sons 1989 AOD equipped LX ran a 14.9 with these mods: B-303 cam Valve work on the heads Mac shorty headers Dynomax mufflers 3.73 gears. After removing the gears the car went 15.4 and these times are from Lebanon Valley Dragway. |
![]() |
![]() |
![]() |
#4 |
street racing junkie
Join Date: Sep 2001
Posts: 231
|
![]() If you have around 4000 plus...get the stage 3 induction kit from Brothers performance. It will give you around 95 hp at the wheels, if you order it with the heads and intake ported...along with some other induction stuff. This includes most of my mods except of course for my block....be sure to get some gears to wake it up if you decide on this one. It is all emissions legal too---I hope
![]() ------------------ 95 gt:347 stroker balanced,edelbrock 150 shot, edelbrock intake and heads ported and matched, 70mm throttle body, 75mm mass air meter, 2040 cam, 1.7 cobra rockers,cold air induction, bbk equal lengths,high flow h-pipe, super chip, 24lb injectors,190lph fuel pump(bbk), under drive pulleys, 4;30 gears,Hurst shifter Has other mods but not too sure what my mechanic did. To see all mods look at my spec page. R/T .641 60FT 1.57 1/8 6.98 1/4 10.81 @ 127MPH |
![]() |
![]() |
![]() |
#5 |
The Dude
Join Date: Feb 2001
Location: Arlington, VA
Posts: 1,262
|
![]() i'd say 15 flatish IF you don't spin. With FMS "b" springs, rear upper and lowers, my 90lx aod vert ran a best of 15.2@92.25
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
SN-92,SN-93,GSS Paxton Ball-Drive Guys Step INSIDE | Mustanguy | Windsor Power | 4 | 02-13-2006 12:13 PM |
Edel. non-smog to AFR smog legal heads? What do you guys think? | Simi Stang | Windsor Power | 10 | 06-19-2003 11:14 PM |
Let me know what u think guys, kinda long | ex-lt1-guy | Blue Oval Lounge | 2 | 03-04-2002 01:11 PM |
dynoed my car guys! | 46stang | Blue Oval Lounge | 7 | 09-11-2001 09:08 AM |
dynoed my car guys! | 46stang | Stang Stories | 3 | 09-08-2001 11:49 AM |