© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-07-2003, 08:03 PM | #1 |
Registered Member
Join Date: Mar 1999
Location: Leesport, PA USA
Posts: 24
|
Got to race finally!
Hello everyone. Finally, the season has started. The car went 11.10 @ 119 first pass!!! second and 3rd passes were 11.07's @ 118. 1.51 60ft. was the best. Bad thing is between the 1000ft. and the first timing light at the top end the car went against the limiter and stayed there. 6500 rpm pill. I don;t want to rev it much higher than that!!! So, 3.73's are going in this week for this weekend. I am running 26 x 10 hoosier slicks. With any luck it'll go quicker! These were the very first 3 passes on the car with the new engine. I'll keep everyone posted.
__________________
89GT, 392, AFR 185's, 11.30:1 compression, Victor Jr., 241/251 dur. @.050 with .570 lift with 1.72's, 750 Speed Demon,1 3/4 longtubes, C4 w/ 8in., 3.73's, Detroit Locker, sway bar off front, Moroso Trick drag springs on all 4 corners, Pro3I control arms with adjustable spring jack, HPM Double adjustable uppers, solid bushings, 70/30's, subframes, 3" X-pipe, 2 chamber flows (3") 11.05 @ 120 1.51 60ft. on 26x10 Hoosier slicks. 11.06 @ 121 1.54 60ft. with the 8 inch and 26x10 Mickey slicks. |
04-09-2003, 01:46 PM | #2 |
Registered Member
Join Date: Apr 2002
Location: somewhere outside of nowhere
Posts: 82
|
You said you are putting on slicks this week. Did you run on street tires? and was the 1.5160ft time with those?
One |
04-09-2003, 02:42 PM | #3 |
Registered Member
Join Date: Mar 1999
Location: Leesport, PA USA
Posts: 24
|
No, the slicks were on the car for those runs. I am getting/got 3.73's put in the rear. The car is almost finished, with this rain I won;t have much chance to break in the gears though.
__________________
89GT, 392, AFR 185's, 11.30:1 compression, Victor Jr., 241/251 dur. @.050 with .570 lift with 1.72's, 750 Speed Demon,1 3/4 longtubes, C4 w/ 8in., 3.73's, Detroit Locker, sway bar off front, Moroso Trick drag springs on all 4 corners, Pro3I control arms with adjustable spring jack, HPM Double adjustable uppers, solid bushings, 70/30's, subframes, 3" X-pipe, 2 chamber flows (3") 11.05 @ 120 1.51 60ft. on 26x10 Hoosier slicks. 11.06 @ 121 1.54 60ft. with the 8 inch and 26x10 Mickey slicks. |
04-09-2003, 03:05 PM | #4 |
or '331 LX Eric'
Join Date: Jan 1999
Location: Columbus, Ohio
Posts: 2,142
|
Nice times, dude! First time out, that's not too shabby with a new motor. You've got a 10 sec car there!
Keep us posted on the results. Take it easy, E
__________________
1991 5.0 LX Coupe - 40,750 miles 331 cu. in. / Tremec 3550 / BFG Drag Radials 12.22 @ 114.31 mph - w/1.89 60' |
04-09-2003, 03:36 PM | #5 |
Registered Member
Join Date: Apr 2001
Location: Staging lane
Posts: 4,337
|
Man you have a killer set-up. You definitely have a 10 second car.
Congrats,
__________________
92' LX-Big brakes, Lots and lots of suspension, GT40X heads, Ported cobra intake, stock cam, Vortech SC trim. 00' Lightning-Stock 88'CRX-13 second ego killer |
04-10-2003, 11:47 AM | #6 |
Rebel Fleet Commander
Join Date: Oct 2001
Location: Huber Heights, OH
Posts: 1,003
|
MMMMMnnn 392 (Sounds like Homer Simpson)
__________________
1993 Mustang GT, PTK w/ T-64 - My Cardomain Webpage 11.25@123.5 on only 8 psi. 10.84@121 on only 1 headgasket "The Truth is, Your the Weak, and I am the Tyranny of Evil Men!" |
04-13-2003, 06:37 PM | #7 |
Registered Member
Join Date: Jan 2003
Location: NC
Posts: 37
|
awesome time, hope that we never meet on the street or track
__________________
02 ss camaro, stock. best et 12.97@108.5 at fayetteville motorsports park soon to be sprayed 92 wrangler 350v8 700r4 |
04-14-2003, 12:27 PM | #8 |
Registered Member
Join Date: Mar 1999
Location: Leesport, PA USA
Posts: 24
|
Alright, this past weekend proved interesting. Car went 11.18 @ 120. Everyone was running an average of a tenth slower than last weekend, the air wasn;t the best and there was a lot of rain Friday night which at Maple Grove means humidity city. But, the car ran great and smooth. 302LX and Dark 50.....thank you, but I still have my doubts. I am just happy that the car is running good and is consistant. We are gonna shoot for a test and tune soon and mess around with some stuff. 02SS, I won't mess around on the street anymore, and I just bracket race at the track. I don;t like racing American cars that much. I would much rather laugh at and spank these imports than a Chevy, Pontiac, or whatever.
__________________
89GT, 392, AFR 185's, 11.30:1 compression, Victor Jr., 241/251 dur. @.050 with .570 lift with 1.72's, 750 Speed Demon,1 3/4 longtubes, C4 w/ 8in., 3.73's, Detroit Locker, sway bar off front, Moroso Trick drag springs on all 4 corners, Pro3I control arms with adjustable spring jack, HPM Double adjustable uppers, solid bushings, 70/30's, subframes, 3" X-pipe, 2 chamber flows (3") 11.05 @ 120 1.51 60ft. on 26x10 Hoosier slicks. 11.06 @ 121 1.54 60ft. with the 8 inch and 26x10 Mickey slicks. |
04-14-2003, 02:58 PM | #9 |
Registered Member
Join Date: Jan 2003
Location: NC
Posts: 37
|
well i wish to never be suckered at the track either. that thing would be a true street race weapon. does it spin any or is the chassis 100% sorted out?
__________________
02 ss camaro, stock. best et 12.97@108.5 at fayetteville motorsports park soon to be sprayed 92 wrangler 350v8 700r4 |
04-15-2003, 10:14 AM | #10 |
Registered Member
Join Date: Mar 1999
Location: Leesport, PA USA
Posts: 24
|
The car hooks quite well actually. This past weekend the 60ft. fell off to a 1.55 but thats not too bad. The air wasn't the best and I was staging a little different. I think with the really good air again it will be back to where it was. It feels to me like it hooks hard, I can feel the front end off the ground and am starting to tell how far it carries it. The suspension is good, but could be better. The only changes I have planned for that right now is a Wolfe Racecraft anti-rollbar. All the twisted motion on the launch is just wasted motion. I don;t think this would be a good true street race car though. Its not all that fast, I mean, I am very happy with it, but there are tons of people out there with street cars running 11's, 10's, 9's, 8's, even 7's in "street legal" form.
__________________
89GT, 392, AFR 185's, 11.30:1 compression, Victor Jr., 241/251 dur. @.050 with .570 lift with 1.72's, 750 Speed Demon,1 3/4 longtubes, C4 w/ 8in., 3.73's, Detroit Locker, sway bar off front, Moroso Trick drag springs on all 4 corners, Pro3I control arms with adjustable spring jack, HPM Double adjustable uppers, solid bushings, 70/30's, subframes, 3" X-pipe, 2 chamber flows (3") 11.05 @ 120 1.51 60ft. on 26x10 Hoosier slicks. 11.06 @ 121 1.54 60ft. with the 8 inch and 26x10 Mickey slicks. |
04-15-2003, 11:54 AM | #11 |
Registered Member
Join Date: Jan 2003
Location: NC
Posts: 37
|
youy should not be so modest. that thing is flying.
__________________
02 ss camaro, stock. best et 12.97@108.5 at fayetteville motorsports park soon to be sprayed 92 wrangler 350v8 700r4 |
04-17-2003, 12:50 PM | #12 |
Registered Member
Join Date: Mar 1999
Location: Leesport, PA USA
Posts: 24
|
Thank you. The weather is supposed to be in the higher 50's on Saturday, so maybe it'll pick up a little bit. I just want the car to be consistent, and it seems to be. We will see
__________________
89GT, 392, AFR 185's, 11.30:1 compression, Victor Jr., 241/251 dur. @.050 with .570 lift with 1.72's, 750 Speed Demon,1 3/4 longtubes, C4 w/ 8in., 3.73's, Detroit Locker, sway bar off front, Moroso Trick drag springs on all 4 corners, Pro3I control arms with adjustable spring jack, HPM Double adjustable uppers, solid bushings, 70/30's, subframes, 3" X-pipe, 2 chamber flows (3") 11.05 @ 120 1.51 60ft. on 26x10 Hoosier slicks. 11.06 @ 121 1.54 60ft. with the 8 inch and 26x10 Mickey slicks. |
04-20-2003, 10:37 AM | #13 |
Registered Member
Join Date: Mar 1999
Location: Leesport, PA USA
Posts: 24
|
Was a good day Saturday!!! The car was VERY consistant. 11.05, 11.06, 11.12 throw away run cause I wasn't lined up right and the car went towards the wall, but I stayed in it. That was first round and I won cause the other guy broke out. Both of us had .004 (.504) rt's!! 2nd round I dialed a 11.10 and ran an 11.07 on the brakes....the car would have run 11.06. So, within 3 hundredths all day it woulda been if I wouldn't have messed up first round. 1.515, 1.517, 1.53 (bad run), 1.515 60ft. CONSISTANT. Second round when I lost I threw away ANOTHER .004 reaction time to his .060--This car never ceases to amaze me. The one guy that races down there in his mustang video taped my launch so I could see what it looks like...I said HOLY S***!!! The left front hangs for a while!!! We are gonna try to get a digital video cam and if we can get one to use I will have video to show everyone. Happy Easter.
__________________
89GT, 392, AFR 185's, 11.30:1 compression, Victor Jr., 241/251 dur. @.050 with .570 lift with 1.72's, 750 Speed Demon,1 3/4 longtubes, C4 w/ 8in., 3.73's, Detroit Locker, sway bar off front, Moroso Trick drag springs on all 4 corners, Pro3I control arms with adjustable spring jack, HPM Double adjustable uppers, solid bushings, 70/30's, subframes, 3" X-pipe, 2 chamber flows (3") 11.05 @ 120 1.51 60ft. on 26x10 Hoosier slicks. 11.06 @ 121 1.54 60ft. with the 8 inch and 26x10 Mickey slicks. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Oct.11 Mid-Mich Toys for Tots Benefit drag race | Doug Dornbos | Ford Show & Go | 0 | 09-29-2003 02:24 PM |
MY FIRST RACE!!! | #1 Pony | Stang Stories | 7 | 07-01-2002 07:55 AM |
I'm finally going to race Legally!!!! | Mercury | Blue Oval Lounge | 6 | 05-17-2001 12:21 AM |
Finally race a supra........well kinda | sedanman | Stang Stories | 6 | 03-05-2001 10:22 AM |
Finally got a race! 99 Cobra! | exgmguy | Stang Stories | 7 | 01-21-2001 02:07 AM |