I have about $5500-6K in my car....including the car.
car=$3800 ('89 notch had 68,000 on it)
Gear installed=$200 (ford mechanic..gets used gears from work)
Rims=$250 used from a guy selling his stang(Convo pro's)
Nitrous kit=$425(5115 dry kit w/ purge,guages, heater & blanket)
MSD 6AL= $80 (used from a swap meet)
Hurst shifter=$50 (old style...used)
Pulleys=$0( took them off my old car)
MAC long tubes=$150 (swap meet)
Flowmaster 2 1/2" cat-back=$350 i think???
The only thing i really bought new.
50/50's=$100(new)
Southsides=$170 (new)
That comes up to $5575 counting the price of the car....My best time is 12.52@112 on 100 shot..13.28 on the motor
I also have an extrude honed cobra upper and lower i got for $425
w/ the edelbrock heads i'm getting this weekend for $600.....That should put cost at @ $7100 (including $500 for labor)
And will absolutely run 11's on that combo.
I figure about 11.60-11.80 @ about 116
So your not getting ripped off...your just not spending wisely.
There are some things i wouldn't buy used...but there is a lot where you can't go wrong
------------------
4.10's,long tubes & 75 shot...Goes 12.50's
Check it out at
http://www.burnouts.webprovider.com
[This message has been edited by NOS_Notch (edited 03-06-2001).]