First thing broke ever...

Skyman · 07-08-2001, 10:08 PM

My oil pump drive shaft broke. First thing to ever break after almost 3 years, and tons of abuse. So i guess its not that bad. Went 12.5's 1.69-1.72 60's all day.

Sky

------------------
-1989 Saleen Mustang #406-
TFS TW Heads, E-303, Edelbrock intake, 70mm TB, 73mm MAF, 24lb injectors, 1 5/8 shorties, Off Road H, 3 Chamber flows, Jaz Race seats, Back seat removed, sub-frames, Roll Cage, and a 80 shot of N20.
12.55@107 Motor

dinomite · 07-08-2001, 11:10 PM

the pump driveshaft broke and it didn't kill the engine?

2FastLX · 07-08-2001, 11:36 PM

Feel lucky? When did it break?

------------------
Gunning for 12's!

My Stang Page
Buy your parts here
ICQ# 42269241

Skyman · 07-09-2001, 12:07 PM

The first time I noticed it was gunning it leaving the track. I look down at full throttle. NO OIL Pressure. I just shut it off instantly.

Skyler

------------------
-1989 Saleen Mustang #406-
TFS TW Heads, E-303, Edelbrock intake, 70mm TB, 73mm MAF, 24lb injectors, 1 5/8 shorties, Off Road H, 3 Chamber flows, Jaz Race seats, Back seat removed, sub-frames, Roll Cage, and a 80 shot of N20.
12.54@107.4 Motor
1.69 60'

red82gt · 07-09-2001, 04:18 PM

Tough break! Hopefully you shut it down in time. When my motor was brand new I watched my pressure guage drop to zero about a block from my house, shut it down popped the hood to see that the oil pressure sender wire had popped off the sender, hooked it back up and breathed a big sigh of relief as the pressure went back up to full after startup.

------------------
GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B&M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty!

07-08-2001, 10:08 PM	#1
Skyman I need 110mph Trap Speed! Join Date: Feb 1999 Location: So, CA Posts: 4,315	First thing broke ever... My oil pump drive shaft broke. First thing to ever break after almost 3 years, and tons of abuse. So i guess its not that bad. Went 12.5's 1.69-1.72 60's all day. Sky ------------------ -1989 Saleen Mustang #406- TFS TW Heads, E-303, Edelbrock intake, 70mm TB, 73mm MAF, 24lb injectors, 1 5/8 shorties, Off Road H, 3 Chamber flows, Jaz Race seats, Back seat removed, sub-frames, Roll Cage, and a 80 shot of N20. 12.55@107 Motor

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Another crank broke!!!	5ohCOUPE	Windsor Power	8	07-12-2004 08:06 PM
Looks like I broke it AGAIN!!!!!!	420nitro	Windsor Power	10	07-01-2004 05:24 PM
broke my K-member	WADS56	Windsor Power	3	05-21-2001 11:05 PM
Got the 4.10's in tonight- good thing I did!!!	Killercanary	Windsor Power	3	03-31-2001 10:30 AM
what does the cirlce thing at the end of the cam do?	LX XLR8R	Windsor Power	4	03-22-2001 04:04 PM

07-08-2001, 11:10 PM	#2
dinomite The Dude Join Date: Feb 2001 Location: Arlington, VA Posts: 1,262	the pump driveshaft broke and it didn't kill the engine?

07-08-2001, 11:36 PM	#3
2FastLX The Photoshop Guru Join Date: Feb 2001 Location: Mecca, Indiana Posts: 1,419	Feel lucky? When did it break? ------------------ Gunning for 12's! My Stang Page Buy your parts here ICQ# 42269241

07-09-2001, 12:07 PM	#4
Skyman I need 110mph Trap Speed! Join Date: Feb 1999 Location: So, CA Posts: 4,315	The first time I noticed it was gunning it leaving the track. I look down at full throttle. NO OIL Pressure. I just shut it off instantly. Skyler ------------------ -1989 Saleen Mustang #406- TFS TW Heads, E-303, Edelbrock intake, 70mm TB, 73mm MAF, 24lb injectors, 1 5/8 shorties, Off Road H, 3 Chamber flows, Jaz Race seats, Back seat removed, sub-frames, Roll Cage, and a 80 shot of N20. 12.54@107.4 Motor 1.69 60'

07-09-2001, 04:18 PM	#5
red82gt Sober voice of Reason Join Date: Nov 1998 Location: Kelowna, B.C., Canada Posts: 1,514	Tough break! Hopefully you shut it down in time. When my motor was brand new I watched my pressure guage drop to zero about a block from my house, shut it down popped the hood to see that the oil pressure sender wire had popped off the sender, hooked it back up and breathed a big sigh of relief as the pressure went back up to full after startup. ------------------ GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B&M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty!