dynamat

stanger8172 · 06-19-2001, 08:13 AM

Anyone ever used Dynamat? I want to lay down something on the floor from the front to rear seats to quiet down the glasspacks with turndowns. Does Dynamat do a good job?

ronny50 · 06-19-2001, 09:25 AM

It works great.

Just make sure to heat it up before
you stick it down. It will go over the contours of the floor alot easier.

------------------
1990 GT 5k Original miles!!
Ripper,Pullies,73 MM C&l Mass Air,8mm Wires,Piaa Headlights,MAC Cold Air (Fender)

Five0 · 06-19-2001, 06:14 PM

A little trick for installing dynamat!
Unroll it and lay it in the sun before you peel the backing off and install.
Let it sit in the sun for about 30min it gets softer and easer to work with.

------------------
James Cox
nochevy@hotmail.com
1991 Mustang LX
12.565 @109.38mph 1.764 60ft

06-19-2001, 08:13 AM	#1 (permalink)
stanger8172 Registered Member Join Date: Nov 2000 Location: Milwaukee,Wisconsin Posts: 380	dynamat Anyone ever used Dynamat? I want to lay down something on the floor from the front to rear seats to quiet down the glasspacks with turndowns. Does Dynamat do a good job?

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sound deadening install: results (Dynamat wannabe)	jonnyk	Audio, Security, & Electronics	2	08-16-2001 08:24 PM
dynamat	stanger8172	Audio, Security, & Electronics	3	06-19-2001 01:18 PM

06-19-2001, 09:25 AM	#2 (permalink)
ronny50 Registered Member Join Date: May 2001 Location: madison, WI Posts: 70	It works great. Just make sure to heat it up before you stick it down. It will go over the contours of the floor alot easier. ------------------ 1990 GT 5k Original miles!! Ripper,Pullies,73 MM C&l Mass Air,8mm Wires,Piaa Headlights,MAC Cold Air (Fender)

06-19-2001, 06:14 PM	#3 (permalink)
Five0 Registered Member Join Date: Apr 2000 Location: middleburg, fl, usa Posts: 1,134	A little trick for installing dynamat! Unroll it and lay it in the sun before you peel the backing off and install. Let it sit in the sun for about 30min it gets softer and easer to work with. ------------------ James Cox nochevy@hotmail.com 1991 Mustang LX 12.565 @109.38mph 1.764 60ft

Sponsored Links