View Single Post
Old 07-21-2001, 01:33 AM   #1
jonnyk
Being stroked is great
 
jonnyk's Avatar
 
Join Date: Oct 1998
Location: Alberta, Canada
Posts: 772
Post First time ever to track: results

Well, I finally decided to drag my car out there and see what it could run. Man that is a lot of fun! The mandatory helmet rule at our track kind of sucked because we were racing into the sun and it made it hard to see the tach, but I managed. My first run ever was a 14.682 @ 94.62 mph, shifting slow and with a 2.28 60'. The rest of my 60's for the night got worse, as I tried some different launch techniques.

Only got 4 runs on the night because it was BUSY. It was also hot, and humid (75°, 75% humidity, and I'm at 2200'). My best ET on the night was as follows:
R/T: 0.894 (I should have been leaving on the 2nd light instead of the 3rd)
60': 2.292
330': 6.163
1/8: 9.414
MPH: 75.71
1000': 12.221
1/4: 14.593
MPH: 94.85
Later in the night I had some time to cool it down as my first 3 runs were hot lapped, no icing intake (didn't even pop the hood) and ran the car on the staging lines. Anyways, I managed to squeak a 95.72 mph out of it.
Since we're high up and bad air, I ran the numbers through a correction thingy and it works out to a 14.18 @ 98.67 mph. Not too bad for my first times ever down the strip. On my last 95.72 mph pass I hooked hard off the line but at 3 grand the tires cracked loose and I blew them off into 2nd gear
Some things I'll change next time:
1) Ice the intake
2) remove rear seat, jack, and spare
3) short belt
4) Launching at idle...couldn't hook with my tight suspension to save my life
5) I may have overfilled my oil a bit on the last change but didn't have time to correct
6) Powershifting 3rd...only powershifted 4th on the last pass, and powershifting 2nd just smokes tires

All in all I had a great time, and will be back before the end of the season no doubt! Later!

------------------
'91 LX Hatch, 17 ROH ZR6's, lowered, 3.73's, offroad H pipe, SN Cobra cat-back, ASP pullies, 14° timing, C&L 76mm MAF, 170A 3G, B&M Ripper on a T5
1991 LX Hatch 5.0L
jonnyk is offline   Reply With Quote