orderd a new trans and clutch today!!
Today I orderd a proshifted tremec "TKO II" and a 11" Ram 900 race clutch W/long style pressure plate and billit flywheel. I can't wait till I get this in my car so I can see what it will run. I'm looking for 11.5 on motor.
------------------ NA 347 W/ stage 2 Canfield heads, out of the box Victor 5.0 intake, solid roller cam, Aeromotive fuel system. MY CAR http://www.mustangworks.com/cgi-bin/...splay.cgi?1288 |
COOL!!! I cant wait till I can start doing major mods like that.
I know a guy with that same tranny and he loves it GOOD LUCK http://www.mustangworks.com/msgboard/biggrin.gif ------------------ 88 mustang gt convertible bored to 306 BBk equal length headers mac cold air fender kit 3.73 FMS gears cowl hood nitto drag radials ford racing clutch flow masters h-pipe 160* thermostat 16 degrees of timing electric fan off 94' t-bird jacobs electronics cap and wires. Edelbrock 1 1/2 inch drop springs. |
5.0 HO, what kind of times is he doing? I'm going for very low 10's to high 9's when I get my blower. Hope it holds!
|
What shop are you getting the trans from? I'm looking to get the same trans and trying to find the best place to get it from. How much do they sell the TKO II's for? ------------------ 86 Mustang GT w/pretty stock 93 5.0 (cam,pulleys,injectors, throttlebody,h-pipe) Motor to be swapped for a 1970 429 +.030, ported heads, solid roller cam, victor intake, 10.2:1 comp, C-6 trans, 3:73 rearend W/moser axles |
|
The guy that I know with that tranny is running low 11's the car already had it in it when he bought it.
|
429 mustang, I ordered it from Liberty transmissions. I paid 2050 for the trans, to have it proshifted, and the drive shavt yoke. If you wanted the trans alone it would be like 1500.
jimberg, You do not need a shortened driveshaft for the tremecs. All you need is a bellhousing if you go with the 3550. |
Hmm, I guess you're right. For some reason I had it in my head that TKOs were longer or something like the T-56s.
------------------ 351W 89 Mustang GT Convertible |
Just installed one a week ago in my 1989 Mustang.
I put in a Tremec TKO, Ram900 clutch pressureplate, steel bellhousing, crossmember, and driveshaft. See photos at: http://members.mustangworks.com/drudis/mustang/tko/ p.s. Look out for the 26 splines on the input shaft, and the special output (21?) spline yoke you need (but stock LENGTH FMS driveshaft), and special offset crossmember. Otherwise its a bolt-in! http://www.mustangworks.com/msgboard/smile.gif ------------------ Darius Rudis Roadracer: Home built t-arm/panhard suspension powered by an S-trimmed motor :-) My Mustang Page |
All times are GMT -5. The time now is 01:02 PM. |