dyno video! (only 300k)
 

went to a dyno party tonight and got a short video of it...make sure you turn up the volume LOUD!

on a side note, it was on a "mustang" dyno and my numbers were 196@5200 rpm (rwhp) and torque was 226@3500 rpm. I dunno how accurate those were cause they had us run through the gears (instead of running 4th gear)

according to the analizer I would run 15.5 with those numbers...my real best is 14.6 @ 96 mph off the bottle

methinks something is off..

anywho, here is the vid... http://www.geocities.com/brandx99/Mvc-002v.mpg

homepage: www.geocities.com/brandx99

Methinks they didn't make a full pass in 4th gear. Should have got it up to speed in that gear and then started.

------------------
'91 LX Hatch, 17 ROH ZR6's, lowered, 3.73's, offroad H pipe, SN Cobra cat-back, ASP pullies, 14° timing, C&L 76mm MAF, 170A 3G, B&M Ripper on a T5
Best ET: 14.593 @ 94.62 2.292 60'
1991 LX Hatch 5.0L

sounded kewl dude! those figures seem a little off. the horse sounds about right, but the torque is awfully low. anyhow the vid was kewl.

----------------------
90 LX Black on Black
Flowbabies, Hurst, h pipe, Mac unequal shorties, lowered, 3.55's,subframes, MSD coil, K&N

Those numbers would equate to about 236hp and 272lb/ft. Seems like the torque is way low at the flywheel according to the dyno based on your hp. I would have expected torque to be more like 300 at the flywheel at least.

Nice video, but it would appear yahoo is already on to you posting the video address. They are hard core against file sharing, the ********. I had to load the video from your main site.

Kick *** video by the way! http://www.mustangworks.com/msgboard/biggrin.gif

[This message has been edited by Unit 5302 (edited 09-02-2001).]

yahoo is a bunch o bastages!