MustangWorks.com : Ford Forums - View Single Post - Roll Call: Old School MW members sound off!

silver_pilate · 01-29-2002, 03:10 PM

I was around as well. And like Matt, I was too poor to contribute (hell, I still am

).

I was looking over that list, and I remember most of 'em. It's been a while since I've seen some of those names, though.

I may not post as much as others, but hey, I'm still a Mustangworks junky. I remember getting some of my first advice on what to do to my car from Mr 5 0. And I was on getting information a couple of years before I found my Mustang. In fact, I actually started watching the boards in 1997 before the board switch. Good to see the old faces are still around.

--nathan

01-29-2002, 03:10 PM	#5
silver_pilate DURKA DURKA!! Join Date: Sep 1997 Location: Lubbock, TX...(TX panhandle) Posts: 1,418	I was around as well. And like Matt, I was too poor to contribute (hell, I still am ). I was looking over that list, and I remember most of 'em. It's been a while since I've seen some of those names, though. I may not post as much as others, but hey, I'm still a Mustangworks junky. I remember getting some of my first advice on what to do to my car from Mr 5 0. And I was on getting information a couple of years before I found my Mustang. In fact, I actually started watching the boards in 1997 before the board switch. Good to see the old faces are still around. --nathan __________________ '91 GT, Coast 347, 9.5:1 compression, full intake, Wolverine 1087 cam, exhaust, Keith Craft ported Windsor Jr. Irons (235 cfm intake, 195 cfm exhaust), AOD, PI 3500 converter, Lentech valve body, 3.73's (4.10's in the works), and Yokohama ES100's out back. Daily Car: '04 Infiniti G35 Sedan 6MT