THe manufacturer of my subframes instructed me to get them welded with beads parallel to the car along the framerail and to weld them 2" at a time then go to the rear, opposite side, back and forth, and NOT to weld the ends. My subframes did not come with brackets because they were intended to be welded only.
BTW the car quit wheelhopping, twisting, rattling, and felt much tighter afterwards.
------------------
GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B+M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty!
|