hah...I see i have people in anticipation.
I had no idea, but i posted this same thing on the corral....I think the proper solution is to roll the paper in a cylinder and route some of the lines around back....its pretty kewl....it basically turns it in to a 3d solution...kinda
------------------
95'gt, 75mm bullet, 30#inj, 75mmtb, Tfs track heat intake, 255 pump, billet fuel regulator, msd btm, underdrive pulley's, pro 5.0 shifter, off road h-pipe, flowmasters, turbo technology's t-04b, all turbo pipes are jet hot coated, running an unequal length header on driver side
MY TURBO MUSTANG!