Printer Problems....

95mustanggt · 10-01-2001, 10:50 AM

O.K. I just had to post this, I thought it was pretty funny. You might have seen it in an email already, but for those that haven't:

"Last week I was with one of my new full time employees named Dave in the lobby when a receptionist complained that her printer wasn't working. Dave horsed around with it and discovered a pen stuck inside the printer. He started to jam his fingers down in to the printer to get the pen, but I told him we didn't have time for that now, and to just put a note on the printer telling folks not to use it and then report it to the Help Desk. So the big stink grabbed a piece of paper and started scrawling on it. I left before he finished the note.

About 20 minutes later, one of my techs comes in and says he was just in the lobby, saw a piece of paper on a printer and went to investigate.

This is what he found..."

------------------
1995 Mustang GT

[This message has been edited by 95mustanggt (edited 10-01-2001).]

jonnyk · 10-01-2001, 04:29 PM

I don't even know what to say here...

------------------
'91 LX Hatch, 17 ROH ZR6's, lowered, 3.73's, offroad H pipe, SN Cobra cat-back, ASP pullies, 14° timing, C&L 76mm MAF, 170A 3G, B&M Ripper on a T5
Best ET: 14.593 @ 94.62 2.292 60'
1991 LX Hatch 5.0L

Unit 5302 · 10-01-2001, 11:08 PM

ROTFLMAO!!!

That's hilarious!!

PKRWUD · 10-01-2001, 11:32 PM

Oh my.

95mustanggt · 10-02-2001, 08:27 AM

My wife didn't get it at first, I had to break up the "penis" to "pen is" for her. Then she laughed.

------------------
1995 Mustang GT

10-01-2001, 10:50 AM	#1
95mustanggt Registered Member Join Date: May 2000 Location: Kamloops, BC Posts: 2,875	Printer Problems.... O.K. I just had to post this, I thought it was pretty funny. You might have seen it in an email already, but for those that haven't: "Last week I was with one of my new full time employees named Dave in the lobby when a receptionist complained that her printer wasn't working. Dave horsed around with it and discovered a pen stuck inside the printer. He started to jam his fingers down in to the printer to get the pen, but I told him we didn't have time for that now, and to just put a note on the printer telling folks not to use it and then report it to the Help Desk. So the big stink grabbed a piece of paper and started scrawling on it. I left before he finished the note. About 20 minutes later, one of my techs comes in and says he was just in the lobby, saw a piece of paper on a printer and went to investigate. This is what he found..." ------------------ 1995 Mustang GT [This message has been edited by 95mustanggt (edited 10-01-2001).]

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
what if any problems with your Modular Model Gt/Cobra?	fixer	Modular Madness	18	04-03-2005 09:18 AM
problems with 6 disk in dash cd player	carlos.elliott	Audio, Security, & Electronics	1	05-20-2004 02:04 AM
HELP: Problems after Paxton Novi 1000 install	Meatman	Windsor Power	3	10-17-2002 06:03 PM
Sick 88 Gt Computer problems?	ziggy_2k	Windsor Power	5	06-02-2002 10:33 PM
'65 - Pull Away Problems - Action Plan	geordie	Classic Mustangs	0	05-14-2002 01:43 PM

10-01-2001, 04:29 PM	#2
jonnyk Being stroked is great Join Date: Oct 1998 Location: Alberta, Canada Posts: 772	I don't even know what to say here... ------------------ '91 LX Hatch, 17 ROH ZR6's, lowered, 3.73's, offroad H pipe, SN Cobra cat-back, ASP pullies, 14° timing, C&L 76mm MAF, 170A 3G, B&M Ripper on a T5 Best ET: 14.593 @ 94.62 2.292 60' 1991 LX Hatch 5.0L

10-01-2001, 11:08 PM	#3
Unit 5302 Registered Member Join Date: May 1999 Posts: 5,246	ROTFLMAO!!! That's hilarious!!

10-01-2001, 11:32 PM	#4
PKRWUD Junior Member Join Date: Mar 1999 Location: Ventura, California Posts: 8,981	Oh my.

10-02-2001, 08:27 AM	#5
95mustanggt Registered Member Join Date: May 2000 Location: Kamloops, BC Posts: 2,875	My wife didn't get it at first, I had to break up the "penis" to "pen is" for her. Then she laughed. ------------------ 1995 Mustang GT