Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-03-2003, 08:33 PM
|
#1 |
|
Registered Member
Join Date: Dec 2002
Location: Philadelphia PA
Posts: 143
|
2V to 4V headswap
Lets just say I was lucky enough to come across a set of 01 cobra heads. The big thing is, what other parts, other than intake stuff, will I need to make these heads work?
__________________
2000 GT 80mm Pro-M mass air, 24lb injectors, 75mm BBK T/B, K&N Filter Cold Air, 1/2" Phenolic intake spacer, Underdrive Pulleys, Dyno Tuned Autologic Chip, FMS Shorty Headers, Mac Prochamber 2 1/2" Off Road H pipe, 2 Chamber Flowmasters, Steeda lowering springs. Steeda Tri-Ax Short Throw shifter, Steeda Power slot rotors w/ Hawk Pro pads, 3.73 FRP Gears. Headwork and Comp cams install in progress. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PI Headswap questions | jimbogt97 | Modular Madness | 5 | 02-20-2003 10:06 PM |
| Headswap heads are here, got a few ? | springs_stang | Modular Madness | 0 | 08-17-2002 01:55 PM |
| Headswap | 97 Stang | Modular Madness | 11 | 08-11-2002 02:53 PM |
| Problem going with headswap before exhaust? | Rally | Modular Madness | 7 | 03-24-2002 12:19 AM |