05-19-2002, 03:14 PM
| #1 (permalink) |
| Registered Member Join Date: May 2002 Location: Indiana
Posts: 7
|  BBK cold air kit I recently installed a BBk cold air fenderwell kit. After I installed the new kit I started to have problems. It idled just fine but, when I would step on the gas it would hesitate big time. It went away as RPM's went up. Is this because I removed the wire mesh screen? Put stock back on and it did go away. I thought my Diablo chip should of taken care of it. Stock MAF on a 2002 GT.
__________________ 2002 Mustang GT BBK-X-pipe,T/B,Cold Air Intake Diablo Chip Steeda Shifter and Pullies 3.73 gears Raven Mufflers |
|      |
|
05-22-2002, 09:59 AM
| #2 (permalink) |
| Registered Member  Join Date: Feb 2002 Location: Arlington Heights,IL
Posts: 231
|  It is most likely because you removed the screen. You'll lose a lot of driveability by doing that. The only other thing is that there could be a vacuum leak. Inspect the air inlet and make sure there are no leak otherwise the car will run badly.
__________________ '97 Laser Red GT Coupe Stock 2V (Pulled Silencer) 4R70W Automatic Ripped off a BLISTERING 15.37@90MPH With a 2.21 60ft Just Installed- K&N Air Filter Coming Soon...... -4.10's -Flowmaster A/T or Magnapack Cat-Back |
|
| |
| Sponsored Links | |
| | |
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Check Coolant light on when cold | Tecknowolf | Windsor Power | 2 | 09-14-2003 07:35 PM |
| cold air intake | TRipSOber | Modular Madness | 13 | 05-01-2003 04:49 PM |
| Cold cold air induction!!!!!! | 01 BLACK GT | Modular Madness | 3 | 07-18-2001 03:10 PM |
| I cannot believe I forgot to ask about Cold Air intakes. | SlowStang2 | Windsor Power | 1 | 07-16-2001 07:26 PM |
| too much cold air? | 93SVTstang | Windsor Power | 17 | 01-26-2001 07:06 PM |
Linear Mode
