Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-27-2005, 04:52 PM
|
#1 |
|
N-V-ME
Join Date: May 2005
Location: SOUTHFIELD,MICHIGAN
Posts: 155
|
Motor To Bell Housing Bolt Pattern
On A 302 How Far Apart Are The 4 Lower Bolts Apart (the Distance Between The Two Lowest Bolt Holes,,, From The Center Of Each Hole To The Center Of The Hole Across From It=== Then The Same Thing For The Hole Above That One===
__________________
88' LX MUSTANG: LINCOLN ROTORS , AIR SUSPENSION FRONT AND REAR, SUBFRAMES, ROLL CAGE, 92' BLOCK, MSD 6AL, ACCEL 8.8 WIRES, ACCEL COIL, EDELBROCK F4B INTAKE (PORTED),2 IN. 4 HOLE SPACERS, HOLLEY 600 CARB.,HOLLEY BLUE FUEL PUMP AN REGULATOR, E 303 (.498 IN. 220 DUR.) CAM, (.535 IN. OF LIFT W/ 1.72 SCORPIN ROLLER ROCKERS), PORTED E7'S, FLOWTECH 1 5/8 LONG TUBE HEADERS, 2 1/2 IN. H PIPE, 2 CHAMBER FLOWMASTERS WITH 3 IN.DUMPS, T-5, 3.73 GEARS, 5 LUG AEROSTAR AXELS, 245-45-17 96' COBRA WHEELS |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bolt Pattern for '99 Mustang - Help | antoine24 | Blue Oval Lounge | 3 | 07-02-2004 10:12 PM |
| need help measuring torque converter bolt pattern | 82 GT | Windsor Power | 0 | 06-17-2003 03:38 PM |
| bell housing for tremec | COBRA66 | Windsor Power | 0 | 12-20-2002 04:00 PM |
| Bolt pattern adapters? | 66StangGuy | Classic Mustangs | 0 | 09-16-2002 02:04 AM |
| need help with c4 bell housing | wes hall | Windsor Power | 2 | 12-06-2001 11:42 PM |