Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-16-2003, 09:46 PM
|
#1 |
|
Registered Member
Join Date: May 2003
Location: williamsport,PA
Posts: 15
|
cobra?? IMRC/ injectors and C&L
hey i have an IMRC stuck open, (intake manifold runner control) can i take them out or do they have to be there..... i know it will put out a code............. but it will also increase my air flow all the time............ and im also thinking about a C&L 90MM MAF and 42LBS. injectors will the computer be able to adjust for this or do i need a chip
__________________
under drive pulleys, K&N air filter, BBK 62mm TB, BBK fuel pressure gage, BBK inline fuel pump,adj. mallory fuel pressure reg., full length headers,flowmasters,off road H pipe, subframe conectors, PRO 5.0 power tower, 4.10's, accell coil packs, thundervolt 50 plug wires, and catapult trailing arms........ |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Full dyno testing on the C&L Plenum, 75mm TB, C&L MAF | 91LX2Bfast | Modular Madness | 4 | 01-23-2004 07:09 PM |
| C&L housing w/calibrated meter?? | sn95gt19 | Windsor Power | 1 | 12-04-2002 03:00 PM |
| Pro-M or C&L?? | jruppert | Windsor Power | 12 | 10-14-2002 03:50 PM |
| Help with C&L 76MM & A9L computer install | venumus93 | Windsor Power | 19 | 05-16-2002 07:58 PM |