© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-18-2001, 12:29 AM | #1 |
Registered Member
Join Date: Apr 2001
Location: Baltimore, Md
Posts: 35
|
Cold cold air induction!!!!!!
this might sound dumb and retarded but here it goes. If someone was to take and evaporater from an a/c unit and fabricate it into the intake boot from the air flow sensor to the throttle body, Would the motor gain any hp or would the 40 degree intake temp hurt it. The reason I say this is because I am a fabricater and want to try something like this. I just wanna know if you think it would hurt it performance wise? Again this is probably a dumb Question
Joe ------------------ 01' Black GT 2 chamber Flows Mach 460, Leather 17"thrust wheels, bassanni x-pipe with cats, BBK Cold Air, Steeda pullies and timing adjuster @ 13*, Steeda Satin Shift Knob Tri-ax shifter A pillar Double gauge pod, Auto meter White Phantom Gauges Fuel Pressure and Vac, Richmond 3:73's Steeda Subframe Connectors.Strut Tower Brace 13.41 @ 102.1mph |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
cold air induction | Toeclicker | Windsor Power | 5 | 08-01-2003 11:48 PM |
WHY is a 80mm MAF and cold air induction a bad combination?? | 96_4.6 | Modular Madness | 6 | 03-09-2003 02:19 AM |
Cold air induction | StangGT02 | Modular Madness | 5 | 07-14-2002 03:32 AM |
Cold Air induction.... $7.83 | rbatson | Blue Oval Lounge | 6 | 02-25-2001 01:27 AM |
cold air induction kit | Brett_C | Small Ponies | 0 | 05-03-1999 05:34 PM |