

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Jun 2001
Location: Poughkeepsie, NY
Posts: 11
|
![]() Would it be worth it to score a custom burned chip for my 1997 Cobra? I just have very basic mods so far... FMS 4.30's, Steeda UD pulleys, tri-ax, Bassani X w/cats and homemade ram-air w/K&N filter. I have heard good things about Autologic chips, what others are good? It seems most cost around $300 or so but what gains are realistic to expect taking into consideration my mods? I am looking to pick up the best bang for the buck horsepower spending around that much money, so a chip is probably the way to go. After doing this I don't plan to do any more mods until next spring or maybe in the winter when the car is off the road. Please inform me of potential gains guys!
|
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Jun 2001
Location: Poughkeepsie, NY
Posts: 11
|
![]() Come on, someone must have experience with chips!
|
![]() |
![]() |
![]() |
#3 |
Registered Member
Join Date: Apr 2001
Location: Sterling Heights,Michigan
Posts: 129
|
![]() Sorry I have no experience with custom chips, but the next mod I would make would be the Steeda Timing Adjuster. I just installed it on friday and my car launches like a mother. It also pull's harder in every gear.
Later,Will ------------------ 98Cobra-BBK Offroad Xpipe,Flowmasters,Mac Cold air,SteedaTiming Adjuster(14deg),Autometer Shift light |
![]() |
![]() |
![]() |
#4 |
Registered Member
Join Date: Jan 1999
Location: allentown,pa,u.s.
Posts: 780
|
![]() I had experience with a chip when I dyno'd my 96, which is set up fairly similar to your 97. I experimented with a few different burns and got about 4hp and torque at best. For $300+ it wasn't worth it and I didn't want to lean my fuel curve or mess with my timing anyway so I didn't buy one. The only reasons I would go back to a chip is either for supercharging, or when I get my short block bored out to 5 liters. The other reason would be to raise the fuel cutoff point. I run into that damn thing way too easily at 7200rpm and my car wants to pull right on past it..
I notice you don't have an aftermarket mass air meter yet. This is what you should do next. The C&L I bought easily added 10+rwhp. I liked it much better than the Pro-M and it was alot cheaper too. Good luck! ------------------ formerly 96cobra89lx306 (96Cobra/softtop-3.73,almdrvsht,fancontrl,steeda sbfrmes+shifter,eibachspgs,KYB's,FR-upper arms,Saleen copy-polished 18's,pulleys,Bassani X pipe(off-road),C&L 80mm,Amsoil etc.. 93 Ford Probe Gt(slower but turns) [This message has been edited by 96SNAKE (edited 08-13-2001).] |
![]() |
![]() |
![]() |
#5 |
Registered Member
Join Date: Aug 2001
Location: St. Louis Park, MN USA
Posts: 7
|
![]() Yes, the aftermarket chip is very worthwhile.
In order to gain maximum benefit from it though, you need to be able to have your car dyno tuned. That is, they make settings in the chip, dyno the car...make some adjustments in the chip, dyno the car... this process is continued until they have maximized what they can get out of your combo. As for manufacturers, my recommendation is Johnson Motorsports in Lucedale MS. www.jmschip.com. I have had nothing but good experiences with them, and Chris Johnson is one of the best in the business at tuning the Fox and Modular cars. ------------------ 1996 Lazer Red Cobra #878 ProM-80, 36# Inj, JMS Chip, Vortech-SQ, Pro 5.0 shifter, Bassani-X, Borla Catback, 4.10s, FMS Alum Driveshaft |
![]() |
![]() |
![]() |
#6 |
Registered Member
Join Date: Aug 2001
Location: Livonia, MI
Posts: 5
|
![]() Get your car on the dyno have a custom chip burned by a proffesional and dyno again to see the gains. I have a 97 Cobra and I got 10 RWHP from the chip alone
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
was there ever such thing as an early hartop mustang with a cobra engine? | domingo | Classic Mustangs | 5 | 04-06-2002 07:56 PM |
More SVT Cobra questions? | Vision | Blue Oval Lounge | 0 | 02-22-2002 10:41 AM |
Custom Mail Order Chip vs. Extender | chadtn2 | Windsor Power | 1 | 08-10-2001 08:47 AM |
Where can I find info on a custom FMS chip? | K.C. 5.0 | Windsor Power | 9 | 08-01-2001 06:41 PM |
New ET 11.457 @ 123.63 in a 99 Cobra! | beefcake | Modular Madness | 1 | 09-25-2000 11:47 AM |