Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-26-2002, 07:13 PM
|
#1 |
|
Registered Member
Join Date: Apr 2002
Location: Portland Oregon
Posts: 247
|
Edelbrock RPM Package
Is anyone out there running an Edelbrock RPM package on a 351 Windsor?
I would like to share some comments and double check some issues. My engine. .030 over 351 Windsor 1970 Block. Forged rods, Forged 9-1 pistons. inches (1262S Felpro Gasket) TFS/TW heads. Ported to 2 1/8 x 1 5/16 2.02 intake 1.6 exhaust RPM dual plane RPM Cam installed straight up 1.6 Roller Tip Rocker Arms Modified Holley 750 Carb 32 degrees max advance Crane Hi-6 and PS-71 Coil Shortie headers 2.5 inch dual exhausts with crossover Edelbrock RPM high flow mufflers C4 Automatic 3.25 Posi rear end. If you are running an edelbrock RPM package I would like to know what your ET's are with whatever gear and transmission you are using. What is your gas mileage? What is your running temperature? What is your overall impression of the package?
__________________
1966 Customized for daily street and highway domination. 358 Windsor running 425 HP C-4 Auto and 3.25 Posi |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Typhoon Intake vs Edelbrock Performer RPM | lucheski | Windsor Power | 1 | 07-13-2004 12:54 PM |
| GM Engines | BLOCKER | Blue Oval Lounge | 2 | 04-13-2004 12:35 AM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Experience with Edelbrock RPM Package | jim_howard_pdx | Windsor Power | 0 | 10-27-2002 01:10 AM |
| flow numbers on edelbrock rpm intake? | Mach 1 | Windsor Power | 10 | 02-07-2002 09:20 AM |