© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
05-08-2001, 08:03 AM | #1 |
Registered Member
Join Date: Dec 1998
Location: Manhattan, KS 66502
Posts: 599
|
Gettin' there inch by inch...
I now have my FMS pulleys and my Pro-M 87mm MAF installed and I like what I feel. It's just about what I expected SOTP wise. I have a harder time getting it to bog in first as it has a little more pull right from the get go. My wife and I are saving for a house so this will be it "mod wise" for a while. Next year I'll swap for some 3:73's and a hiflow hpipe. It's a small start but every little bit helps in the long run.
Just thought I'd share. Brett ------------------ 66 Tahoe Turquoise Coupe Laser Red 96GT Ragtop 30 Years & 30 inches apart in the driveway! [This message has been edited by Stefan (edited 05-08-2001).] |
05-08-2001, 03:51 PM | #2 |
Registered Member
Join Date: Jul 2000
Location: Minot AFB, ND
Posts: 207
|
Congrats on the mods, Stefan! Pulleys are good bang for the buck. The MAF should have waited and 3.73's or H-pipe should've been put in, though. The MAF will increase your throttle response, but you'd be lucky to see any hp out of it without being blown(the car ).
------------------ T-Bones 1997 Cobra#6342 born 6-11-97 Wht/blk, Pro 5.0,FRPP 4.56's, aluminum driveshaft, FRPP throttle body, C&L 80mm MAF, K&N, Steeda U/D pulleys, Steeda timing adjuster, Flowmasters, s/f connectors, FRPP pro springs, BBK caster/cambers. My old 96GT |
05-08-2001, 04:01 PM | #3 |
Registered Member
Join Date: Dec 1998
Location: Manhattan, KS 66502
Posts: 599
|
Yah, I might be working backwards on a few of these mods but I couldn't pass up the deal I got on them. They are the pulleys and MAF off of Hammer's Stang. I got them highly discounted and as I had planned on those two bolt-ons in the future anyway I went ahead and got them. I can't wait to see what gears are gonna feel like as well as getting rid of 4 cats... all in due time.
It's gettin' tough, though, 'cause patients is a shirt I don't wear ------------------ 66 Tahoe Turquoise Coupe Laser Red 96GT Ragtop 30 Years & 30 inches apart in the driveway! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3 inch piping | 01whtegt | Modular Madness | 3 | 08-15-2002 12:26 PM |
are mac's 3 1/2 inch tail pipes for my setup | Chevysucks | Windsor Power | 1 | 03-18-2002 03:46 PM |
9 inch rear | GTSteed89 | Windsor Power | 1 | 01-25-2002 01:46 PM |
Cubic Inch of the 4.6? | 98'MustangGT | Modular Madness | 7 | 05-04-2001 11:03 PM |
9 inch rear ends | Fostang | Classic Mustangs | 12 | 02-19-2001 07:23 PM |