

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Mar 2002
Location: Bradenton, FL
Posts: 2
|
![]() I have been following this forum for some time now looking for information about modifications I can accomplish on my 99 gt. Now I have a couple of questions for all you Mustang gurus. I want to lower my 99gt convertible. I would like to go no further then a 2 inch drop. What spings should I be looking at to accomplish this? And will it require Castor Cambor plates to bring the alignment back into spec?
__________________
Only those who see the invisible can do the impossible. |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
4 banger springs in a vert? Dumb or no? | tireburner163 | Windsor Power | 6 | 03-03-2003 07:12 PM |
can I use hardtop springs in my vert? | tireburner163 | Windsor Power | 5 | 02-25-2003 02:46 PM |
Did MM send me the wrong H&R SuperSport Springs for my '98 GT 'vert? | GaryDawg | Modular Madness | 2 | 08-05-2002 02:03 PM |
Lowering my '96 - Springs? | ncbflo | Modular Madness | 1 | 06-30-2001 09:27 AM |
Edelbrock/Eibach lowering spring vs. Eibach lowering springs - diff.? | green94droptop | Windsor Power | 1 | 06-16-2001 02:20 AM |