HELP Quick w/ HPM Driveshaft Loop Install ???
 

I have all day Friday to install a HPM Driveshaft Loop in my 97 Cobra. I need this to be able to run in the Modular Shootout Street Bracket on Saturday.

Can I just use all the bolts and washers that came with it or do I need special hardware per NHRA rules?

Are the front seats hard to get out?


Any tips on this install would be greatly appreciated.

Later, Jason



------------------
1997 Cobra -- #572 of 6,961, White, Steeda Tri-Ax shifter, WMS Velocity Tube, Dynomax Race Magnums, HPM Megabite Jr. Control Arms, FMS "C" springs, Manual Fan Switch, Autometer Shift-Lite, BFG Drag Radials 275/50/15

<A HREF="http://www.mustangworks.com/cgi-bin/ViewIt.cgi?http://www.mustangworks.com/cgi-bin/moi-display.cgi?772" TARGET=_blank>

Click here</A> to see my Cobra!

The front seats are easy to take out, four bolts on each side. As far as using all hardware that came with it, I would think you'll be fine, as long as everything is nice and tight............ Good Luck

------------------
'97 GT, full lenght MAC headers, MAC Pro chamber h-pipe, Mac 2.5" Cat-back w/chrome tips, AODE 4W70R, K&N, Eibach springs and a 150 NOS wet shot system. Coming very soon, 4.10 gears, trany upgrading, Saleen body kit, and some medium suspension work.