© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-25-2003, 08:45 PM | #1 |
Registered Member
Join Date: May 2002
Location: Chapel Hill, NC - USA
Posts: 188
|
Hurst T-bar handle question
Hey guys, just installed my Hurst T-bar Handle, and have a small problem... its sitting right and working great... but the Handle comes with a bolt you put on first, then tighten against the handle to make sure the handle stays in the position you want it to be in.
problem is, that when griping the handle hard, the nut kinda digs into my hand..... any ideas as to aleviate this problem? Torinalth
__________________
When you finally shut down the car, just sit back and remember the run.... win or lose, you know it was a surge of adreneline |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Door Handle Replacement | Dan_Cicero | Small Ponies | 1 | 05-28-2003 03:57 PM |
Another "How to" question... | got5.0? | Windsor Power | 3 | 12-15-2002 07:15 PM |
hurst shifter question | jjmel | Modular Madness | 6 | 07-14-2002 10:18 AM |
Door handle help | HellRaiser92 | Blue Oval Lounge | 1 | 04-20-2002 04:03 PM |
will steeda tri-ax handle fit on my hurst short throw shifter? | SHaFT7 | Windsor Power | 1 | 06-10-2001 03:10 PM |