I'm new to Mustangs, Question about alignment after Lowering

JHC83C · 09-18-2005, 04:36 AM

I've been driving Miatas & Corvettes for the past 10 years, Recently picked up a 2003 GT.
I'm thinking about lowering it with the "Bullit" suspension kit from "StangSuspension".
Should I keep the stock alignment specs or go more agressive for straight-line tracking ?
I have no problem if I have to rotate the tires every 5k for wear.

blue00gt · 09-23-2005, 04:34 PM

For a mild daily driver that you want to turn better I'd max out the positive caster if you have stock plates (-5 or -6 degrees is good if you can get it with the stock plates) and go with -3/4 to -1 degree of negative camber. This will improve the cornering grip in the front and the camber curve and not mess with tire wear too much, which are both good things since in stock form Mustangs tend to push. If you're just looking to go straight then the stock alignment should be fine.

09-18-2005, 04:36 AM	#1
JHC83C 2003 GT Join Date: Sep 2005 Location: Southern NJ Posts: 1	I'm new to Mustangs, Question about alignment after Lowering I've been driving Miatas & Corvettes for the past 10 years, Recently picked up a 2003 GT. I'm thinking about lowering it with the "Bullit" suspension kit from "StangSuspension". Should I keep the stock alignment specs or go more agressive for straight-line tracking ? I have no problem if I have to rotate the tires every 5k for wear.

09-23-2005, 04:34 PM	#2
blue00gt Mustang Addict Join Date: Jan 2001 Location: McKinney, TX Posts: 1,294	Re: I'm new to Mustangs, Question about alignment after Lowering For a mild daily driver that you want to turn better I'd max out the positive caster if you have stock plates (-5 or -6 degrees is good if you can get it with the stock plates) and go with -3/4 to -1 degree of negative camber. This will improve the cornering grip in the front and the camber curve and not mess with tire wear too much, which are both good things since in stock form Mustangs tend to push. If you're just looking to go straight then the stock alignment should be fine. __________________ Strike down the unroadworthy! 2000 GT Atl. Blue: '03 Cobra motor - 465rwhp/473rwtq, T-56 6-speed, full MM TA/PH & tubular K-member suspension, Saleen body, 17" Torq-Thrust II's, M/T ET Street radials, and lots more '94 Rio Red Cobra: All the bolt-ons, 3.73s

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
lowering Springs Question	MaHFiVeoH	Windsor Power	10	08-19-2012 08:26 PM
Safety Issue 64 - 70 Mustangs	Mach1 Cobra Jet	Classic Mustangs	20	07-11-2005 08:06 PM
Question on alignment specs?	MJ86GT	Corner Carvers Delight	5	05-03-2003 10:10 AM
question on options of 68 mustangs	68mustang	Classic Mustangs	2	11-03-2002 08:22 AM
BBK Progressive Lowering Springs... 1 Quick Question...	BowTie Eater 5 Liter	Windsor Power	2	05-09-2002 11:12 AM