Installing CATS in an off-road pipe
I just purchased a couple of high flow cats that I plan on welding in a BBK offroad pipe that I have laying around. Do you guys think it would be easier to weld them in before or after the pipe is installed? I realize the work will have to be precise if done before installation in order for it to line up correctly. I would be easier to weld out of the car. Also, do stainless wire/rods have to be used when welding stainless to aluminized steel? Thanks for any feedback, I hope to do this on Saturday.
------------------
'97 Cobra, Rio Red, MAC Cold Air Kit, 3.73s, NGK V-Power
|