06-04-2000, 08:47 AM
| #1 (permalink) |
| Registered Member Join Date: Jul 1999 Location: Dearborn, MI
Posts: 53
|  Kiss another T-45 bye! Just broke my T45 the other night. It is under warranty, so it will be replaced by the dealer, but I am begining to think I would rather go with a Tremec. Can anyone offer any information on what I would need to do this? Also, what would it cost for parts? Any information is appreciated. |
|      |
|
06-06-2000, 02:08 PM
| #2 (permalink) |
| Registered Member Join Date: Jan 2000 Location: Ogden Utah
Posts: 58
|  New TREMEC 3550 will run you about a thousand, shifter $200 and bell housing another $250....Add another $100 to get your drive shaft shortened and rebalanced.......While your there take a good look at the clutch and throw out bearing,,,,replace if there is any doubt....Also check the flywheel for grooves and have it trued if necessary or go to an aluminum flywheel..... ------------------ |
|
| |
| Sponsored Links | |
| | |
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| All time Favorite song? | Coupe Devil | Blue Oval Lounge | 41 | 12-23-2001 09:42 AM |
| Where was your first kiss? | StangLady | Blue Oval Lounge | 20 | 01-23-2001 11:12 PM |
Linear Mode
