MustangWorks.com : Ford Forums - View Single Post

4cammer · 02-12-2000, 10:16 PM

Hey guys. Just wanted to let you know that I got my MAC catback setup installed on my '96 Cobra today. It took about 3.5 hours, and I had to cut the stock pipes to get 'em off, and make some monior adjustments for clearance (brake line), but it's all done.

With the stock h-pipe and cats, the sound, to me, is damn near perfect. It's not too loud, but it has a deep rumble at idle, and the same deep tone up through the gears. Sounds real nice. I think I'm going to like it a lot, though it might not be enough. I may have to break down and buy a high-flow cat h-pipe to go with it. We'll see. Anyway, thanks to all of you for your recommendations. The Flowpaths do sound good!

------------------
'96 Cobra - K&N, Pro-M 77, Pro 5.0 shifter, 3:73s, Cobra "R"s, Steeda control arms, pulleys, springs and caster/camber plates.

02-12-2000, 10:16 PM	#1
4cammer Registered Member Join Date: Aug 1999 Location: Florida Posts: 99	MAC Catback is on....FINALLY! Hey guys. Just wanted to let you know that I got my MAC catback setup installed on my '96 Cobra today. It took about 3.5 hours, and I had to cut the stock pipes to get 'em off, and make some monior adjustments for clearance (brake line), but it's all done. With the stock h-pipe and cats, the sound, to me, is damn near perfect. It's not too loud, but it has a deep rumble at idle, and the same deep tone up through the gears. Sounds real nice. I think I'm going to like it a lot, though it might not be enough. I may have to break down and buy a high-flow cat h-pipe to go with it. We'll see. Anyway, thanks to all of you for your recommendations. The Flowpaths do sound good! ------------------ '96 Cobra - K&N, Pro-M 77, Pro 5.0 shifter, 3:73s, Cobra "R"s, Steeda control arms, pulleys, springs and caster/camber plates.