MustangWorks.com : Ford Forums - View Single Post

Ares · 10-19-2002, 11:24 PM

You can find a universal type tool at Auto Zone or probably any decent auto parts store. It is boxed shaped with 5 sides having different pegs sticking out. Some square some round. The one I bought I had to cut off two round pegs(had 4 on side I needed) so that it would fit the two slots on face of piston.

The piston on rear caliper screws in clockwise.

10-19-2002, 11:24 PM	#7
Ares Registered Member Join Date: Oct 2000 Location: Saxonburg, PA, USA Posts: 236	You can find a universal type tool at Auto Zone or probably any decent auto parts store. It is boxed shaped with 5 sides having different pegs sticking out. Some square some round. The one I bought I had to cut off two round pegs(had 4 on side I needed) so that it would fit the two slots on face of piston. The piston on rear caliper screws in clockwise. __________________ Ed.. My Mustangs webpage NMRA M/M 7222 2000 Mustang GT - 5 speed Race weight w/o driver 3086lbs, 3250 w/ driver Best 1/4mile run to date: 12.79@105.96, 60' 1.76sec.(10-27-02) Best MPH 106.03(10-27-02)4.10gears Last edited by Ares; 10-19-2002 at 11:29 PM..