© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-13-2001, 11:38 PM | #1 |
Registered Member
Join Date: Sep 2000
Location: New Hope MN USA
Posts: 276
|
Valve guide seals?
What exactly does worn valve guides mean? Can they be replaced, or does that mean you need to get a new short block, I am confused. I would appreciate any guidance on this issue...Thank you in advance, as far as I know I do not have this problem, but have heard others mention it.
------------------ 91 LX Convertible Gray on Red B&M Shift improver kit,ASP red alum. underdrive pulleys, Richmond 3.73 gears, 1 5/8 Flowtech long tube Headers and off road h-pipe, Flowmaster 2-chamber cat-back with S.S exhaust, MSD 6A Ignition with coil,Cap and rotor, Taylor Pro wires, K&N 12" conical filter system, Jet stage 2 performance chip and just purchased some GT40P heads, looking at exhaust, Lentech Street Terminator plus on it's way... |
03-13-2001, 11:48 PM | #2 |
Registered Member
Join Date: Jan 2001
Location: Minnesota
Posts: 177
|
Kevin-
The valve guides are in the heads, ussualy brass?? If those are worn than oil can get into the chambers much easier, and cause valve train problems. The seals are the umbrella or positive lock type that ride on the valve stem inside the springs, they keep the oil out of the chambers. With your new heads you won't have to worry about either. Jeff ------------------ 87 GT, BBK shorty's, offroad H-pipe, ASP pullies, 70mm T.B., Cobra intake, no smog pump, Windsor Jr irons, Comp cams 1.6 rollers, F303 cam, H.D. export W.P., Tri-Ax, FMS subframes, Battle boxes, SSM liftbars, FMS King Cobra clutch, mass-air conversion, 73mm C&L, 24lb injectors, BBK fuel pressure regulator, 3/8" no EGR spacer, and other piddly sh*t. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Valve seals too tight? | Hozer 88GTConv | Windsor Power | 0 | 03-09-2004 02:55 PM |
Bad valve guide? | Hozer 88GTConv | Windsor Power | 6 | 01-23-2004 03:14 PM |
valve seals | rtschoneman | Classic Mustangs | 1 | 03-15-2003 04:19 PM |
Valve guide or valve seal? | Hozer 88GTConv | Windsor Power | 10 | 01-21-2003 03:08 PM |
valve seals | 89GTAtcoRaceway | Windsor Power | 1 | 03-28-2002 09:04 PM |