MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Modular Madness
Register FAQ Members List Calendar

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 01-12-2003, 12:40 AM   #1
Tim Lester
Registered Member
 
Tim Lester's Avatar
 
Join Date: May 2002
Location: IL
Posts: 32
Thumbs up My Dyno Results with JMS Chip

I went to dyno my Cobra today with a JMS chip. I did 2 base runs with the chip off, 2 runs with the first tune, 3 runs with the second tune, and 3 runs with the third.

The base pulls started off good with a 309.2 rwhp and a 299.7 rw/tq.

Once I turned on the first tune there wasn't much of an increase over the base with a 309.5 rwhp and a 301.4 rw/tq, I was not pleased. Tried it again, barely anything.

Then I tried the second tune, the power went up to 312.1 rwhp and 305 rw/tq. which was a 2.9 rwhp and a 5.3 rw/tq. increase. The other 2 were about the same.

Finally, I tried the third tune. The first pull was a 311.2 rwhp and a 302.6 rw/tq. which was a 0.9 hp and a 2.4 tq. decrease, I was kinda dissapointed. Tried it again, a little increase but not much. Finally, the last run was a good one. I was quite pleased

Here's the link: http://www.svtperformance.com/forums...threadid=28034
__________________
1999 Mustang Cobra

Solid Axle w/ 4.56's
Magnaflow Cat-Back
Dr.Gas O/R X-Pipe
JBA 1-5/8ths Shorty Headers
Homemade Powerpipe
March Pulleys
JMS Chip
Steeda Tri-Ax Shifter


Best E.T. w/ parts listed & BFG 275/40/17 D/Rs (10-26-'02; not including JMS Chip)- 12.95 @106.82, 1.79 60FT.

Best MPH- 107.43

New Best MPH (4-26-03)- 109.45

316 RWHP/ 309 RWTQ
Tim Lester is offline   Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
331 Dyno results 302 LX Eric Windsor Power 12 04-29-2004 10:13 PM
crane cam dyno results are in ,kind of? 46stang Modular Madness 5 12-04-2001 08:58 PM
Dyno test Holley/Diablo custom chip exgmguy Windsor Power 3 10-22-2001 05:23 PM


All times are GMT -5. The time now is 07:50 PM.


SEARCH