Need some input regarding Weld wheels
 

I bought 15x5 and 15x10 Weld Draglite's for my car today. Now problem is the front ones hit the caliper. Are those who are running these type wheels using some sort of spacer behind them? I cant get the Weld Draglite XP's since Weld stopped making them in 15" diameter's.


------------------
2000 GT Laser red-5speed
MAC Cold-air Induction
MAC 2 1/2" cat back exhuast
275/50-15 Drag T/A's used at track
Best Quarter mile run to date: 13.50@99.97 (1.87 60')

Just use a 7/16" spacer and you should be fine but to be 100% safe you should look into putting 2.5 or 3" race studs up front. I used the Steeda 3" up front to be legal at the track.

------------------
00 GT, MAC Offroad H, Steeda Pulleys, Steeda Timing Adjuster, FMS 4.10’s, Flows w/turndowns, UPR shifter, UPR subframes, UPR LCA’s, Air Filter, Lakewood 70/30 & 50/50, Weld Pro Stars, Nitto DR’s, 253.8RWHP/292.8RWTQ
Best on DR's 13.09@103.92 (1.81 60ft)
Best on ET Drags 12.99@104.60 (1.67 60ft)
M/M 100
88 LX coupe X-FHP, 12pt Cage, UPR K-member, 31 spline rear, full spool…

Thanks, I should have posted I figured this out. Can't wait to get tires for the front wheels and some warm weather so I can mount these things http://www.mustangworks.com/msgboard/smile.gif

Thanks, I should have posted I figured this out. Can't wait to get tires for the front wheels and some warm weather so I can mount these things http://www.mustangworks.com/msgboard/smile.gif